Viewing all customer Discussions for:

26-398 Round End Pivot Bar, 2-1/2"

Two pivot bars broke in half on my vinyl window. Trying to find the correct replacement part.

we are looking for a dozen minimally please let us know if you can be of any help

Looking for 10 to 20 pivot rods that have a defect where they break at the screw hole (closest to edge of window). Also there is the occasional break of the pivot piece (other picture) where I should get a few as well. lease let me know asap.

This piece broke off my kitchen window. When I try to open the window it will almost come off the track and fall to the floor

These pins are attached by screws on either side of the bottom on window and go into a metal U to make window go up and down but they are bent .

Holds up the top window on double hung window

Hello. The picture is all I have to offer. I have to parts number. It is the part that holds the window in place. It broke off when window was tilted at too much of an angle. Hoping you can assist.

I need a bunch of replacement pivot pins for 'Regency" replacement windows. Total length is 2 3/4"

I would like assistance to purchase the correct pivot bar. Thank you for your assistance.

Surfed your catalog a bit and I think it's a #4 coil spring series 150 (#4 stamped on the top clip in picture). All the other hardware looks good. Should I order just the coil springs?

17" by 21" bathroom window. Balances are missing and/or broken. Anlin Window. Is it possible to obtain parts to repair?

Hi, The part I'm trying to identify in the picture is partially broken ... the white plastic should extend a little further upward on either side at the top of the part. The part sits in the side of the window panel and allows the window to glide up and down with ease, having a metal rod from the w ... (cont.)

We need a left and a right assembly. These are the only parts left. Not sure what is all needed.

I recently purchased two S140-10 coil balances, left and right. They went in easily, however, the existing pivot bar is to big to fit in S140-10 slots. The existing pivot bars are 1 1/4 inches long with two screw holes as shown in the picture. Can you tell me which Swisco pivot bars will fit my s ... (cont.)

Moved into a house with multiple windows broken as seen in the first photo. Determined it to be a coil balance, but it was in pieces when I got it out. I'll be honest - not sure how they got them in in the first place as there is no distinct opening in the channel to pull them out, had to pry out wi ... (cont.)

Trying to locate a replacement one of these, it comes out of a tilt window, hannasmith is the only sticker I can find, there are no glass etchings in the corners etc

This part is attached to the lower sash on a double hung replacement window. The pics show all labels I could locate. This part locks into the window "weight" part on the side that prevents the sash from falling down.

I need the left and right balance assemlies for Anlin window m/n H-R30-48x96 as well as replacement tilt window sash pivot pin (3")

Hello , I need appropriate pair of pivot shoe and pivot bar for all 3 windows; Please help , thanks . Kyle

I don't know what the small nub coming from the window is called. It snaps into the plastic part of the window frame which assists the window up when we open the window. I have a window that is somehow missing these nubs. Can you help?