Viewing all customer Discussions for:

39-027E Ellipse Style Single Arm Operator, 9-1/2"

Although pictured is a LH crank I do primarily need the RH crank although I may replace both.

I amlooking to replace the pieces that attach to bottom and window and actual window frame...you can see the rusted parts, we can't close the window completely because it won't slide properly on the far left corner. I can't get the part out because it is soo rusted...the crank works fine though it's ... (cont.)

I want to replace the crank mechanism

The bushing keeps popping out of the track. If there is a bushing replacement I'll take it but I think I need the arm at a minimum.

I need a right and a left

Need left and right 11-1/2" approx

Hi - we are looking to replace a single arm operator (appears to be 9.5" long) that is installed on a roughly 20" x 24" casement. We have not been able to identify a part number on the operator, but are looking to replace the operator at a minimum, and potentially the track that sits on the casement ... (cont.)

Hi, I just got your last order, and it worked perfectly! Maybe you can help me: left hand window crank, Truth is the label, and the only number is 30744... I attached two photos incase they can help. I need the whole system, as the previous owner took it completely off (and I have another window l ... (cont.)

Shoe? (part that goes in track) appears to be missing a white maybe plastic cap. First photo shows window with cap missing. Third photo shoes what it should look like. Any ideas? Thank you!

I need to replace CARADCO windows cranks. I see one on your website and wonder if it will fit. Does CARADCO has many sizes? Thanks!

Gears on the crank are stripped and the mechanism needs to be replaced. I cannot get the crank mechanism out without pulling off the lower frame of the window sill. The piece could have been installed in the 1950s when the house was built. Before I tear apart the window frame I want to make sure tha ... (cont.)

Arm looks to be around 9-1/4 inch

I believe all the hardware is truth. We have 4 windows each of 2 locks (8 total). The operators are on two right opening windows and two left opening windows. I included a picture of the operator hinge in case that would help of need replacement. thank you, Morgan

I need to replace my operator on my casement window. It is stamped Truth and I can see a number 30744B. The arm is about 8". See the attached photos.

Made in USA; it says TRUTH on the top side of the arm

Hi I'm looking for a replacement window operator for a Nordic brand has a number 40055 stamped on the bottom. Pictures uploaded.

Hi, I have a small Norco casement window that I believe is original to our house, which would make it about 42 years old. I have included pictures of the working casement window, as the one I need help with is missing parts. The markings on the articulating arms appear to be a brand called, Truth. T ... (cont.)

I purchased an Ellipse style operator arm (#39-0273).as a replacement for a Truth (#45251).Everything matches up except the roller at the end of the arm. The replacement roller is thicker and plastic, where as the older arm uses a thin steel roller.Did I order the wrong part, or do I need to to ord ... (cont.)

Hello, I am looking for a replacement window crank. I see Hurd written on them but no part numbers. Please see the attached pictures. Thank you for your help identifying the part.

repainting trim and want white hardware. Need casement operator, crank and latch. Existing arm is about 9.5" long and the window hinges on the left as I face out. The window cranks have a weather shield logo.