Viewing all customer Discussions for:

81-266 1-1/4" dia Roller And Axle Kit

The housing is good but I think there used to be a black wheel on the outside of these rollers.

I ordered Product Code: 81-087 based on some customer questions & feedback, however, I don't think these are going to work. The wheels don't retract enough to provide the clearance me door requires. Do you have any ideas. Sorry no measurements, I may need to disassemble again to provide this deta ... (cont.)

I would like to replace all the wheels on four, 4' x 6.5' mirrored closet doors. We have powdercoated the frames which now look beautiful. All we need are the wheels. The old wheels are imprinted with Product of Del Mar Eng Co Long Beach CA Pat 3,670,357 Length from wheel end to t post portrusion ... (cont.)

Looking for replacement Roller for Aluminum patio doors. Attached are pictures. I believe the roller bearings are worn out. Others two doors roll like butter. I welcome and await your expert advice.

Found the part on another website but noted it was discontinued Housing Width:3/4-inch Housing Tab Style: Unique Housing Material: Steel Roller Diameter: 1-1/4-inch Roller Edge Type: Concave trying to find replacement or second best option

About 23 years old. No names or numbers.

I am looking for two replacement rollers for an older sliding glass door. We are unsure of the make of the door. The measurements for the roller are 2"x3"x3/4". We also are looking for the top rollers 1 1/4" dia.

The door frame says PeachTree Door CITATION

There are no names or markings.

1970s installation

I have an aluminum sliding door in our basement. I believe it might be original with the house ~1969. The nylon rollers are shot, and I'm trying to replace them. I got the door out, only to find that I believe the roller assemblies are riveted to the bottom stile of the door. I marked the rivet ... (cont.)

Hi, Looking to replace the following rollers on two patio sliding doors on my home. The ball bearings are toast. Thanks. Marc

I have a job to replace rollers for a home. Built in 1957. Large single pane doors. Never seen these rollers with clips. Any ideas? Thanks

Hi I need help identifying this roller wheel for my glass sliding door.

Greetings, I need to replace the rollers on my patio door. The dimensions are:2 1/2" x 5/16", the wheel is 15/16". Please help image.jpg Rob

This screen door came with Peachtree Citadel doors in 1999. I need both lower and upper roller sets.

Need to find out if these are available within 60 miles of Warren Arkansas If not, then need to know where to order online Thanks in advance

No markings on my rollers. Similar to 81-085 however, my wheels are metal.

I have a 1963 home with old sliding aluminum glass doors. There are two different roller assemblies. The rusty one, with only one screw hole sits at the rear of the door. The rusty one has the pin hole worn, so I cannot just replace the wheel. The one with the two holes sits at the front of the d ... (cont.)

Hello, I have a Peachtree screen door circa 1996. The rollers are stuck and I'd love to replace them. Is this particular roller assembly still available? Thank you!