Viewing all customer Discussions for:

26-148 Vent Latch

Our house is fitted with vinyl replacement windows from the late '80s. Most are sliders and have pop out slide stops. I haven't removed any, but I have a broken one that offers a glimpse as to the size & shape of the openings. I estimate the rectangular opening to be 3/8"x 2-3/8" Any help is greatly ... (cont.)

opening in window frame for part is 2.375 length x.375 width Thank you

I forgot to take pic. Of the wedge that pops out the windows was installed in 1995.

I'm looking for one of the window locks and two for sliding doors as pictured Can you help?

The windows are PlyGem CertainTeed. The label reads June5,2008 1104380940011800000. I have ordered 409 series 170 coiled balance springs from you in the past for these windows. I had a representative from Ply Gem Windows look at them, and although the parts will not be covered under the warranty, ... (cont.)

Hi, I have a set of roughly 10 year old Certainteed slider windows and one set has vent latches that have failed. I am trying to replace the latches but these windows take latches that are 3" long and I am having a hard time finding them. The ones that I found on your site are 2 1/2" long and I am p ... (cont.)

Hello! These are the parts I need. So, I need you to give me the number of these pieces so that I don't buy the wrong one. I will need 10 white pieces from each unit, with the exception of the piece in Photo 5 (4 pieces + screws). These are the numbers I can see: Photo 1: I 11079 PAT. 4824154. On ... (cont.)

This part seems to be very similar to your part 26-148 except the dimensions are slightly longer and this part does not seem to have the metal wire underneath. I would like 6. Can this be special ordered? Diane

I'm looking for a safety latch as shown in the attached images.

I have Certainteed windows that were installed about 14 years ago and a few are in need of vent latch replacements. The existing vent latches are 3" long top to bottom. Your 26-148 latches looked like they were the ticket until I noted that they are only 2-1/2" long top to bottom. The slots in the ... (cont.)

I have new construction certainteed windows from 1996. I am looking for the sash tilt latches for the lower sash. And also the security stops which are installed on the upper sash Thanks Dan

Hi - I am looking for replacement sash vent stops for my replacement windows. Purchased in 1998, Certainteed vinyl replacement BRYN MAWR II model. Manufactured by Advanced Window Systems in NJ. Thanx wayne

I have certainteed windows and I have a broken security limiter. Color is "off-white"/"tan" and I need to get a new one for replacement. I have a picture attached of the broken one and one that is operable.

Locks window to a 2" opening

I am looking for replacements for the vent latches on my CertainTeed Brynmawr II windows. The existing latches are 2-1/2" high by 1/2" wide. Your Part No. 26-148 seems to be very similar, except that my original latch does not have a flat spring attached at the bottom.Will your Part No. 26-148 work ... (cont.)

I am looking for this type of latch

Hello, I'm looking for this snap-in window stop for a Certain Teed window. Do you carry this item? There is a "3" on the side of this part. Thank you.

We have Heritage II double hung replacement windows and the window security stop is broke on all the windows. Can you provide replacement parts?

Unlike your replacement this latch is pushed up and it extends out. You push it in and down to close it. It is the same size as your part. Will your part work as a replacement.

have this part?