Viewing all customer Discussions for:

26-405 Rounded End Pivot Bar, 2-7/8"

I have an Anlin Catalina single hung window. The parts that are broken are metal pieces that are inserted into the sash and connect to the coil balance. There are two of these in the sash (one on each side) and both are broken.

Greetings. I have 5 of these windows. This is the only one I can open. The rest the "counterweight/spring/whatever" system has broken on. I'd like to fine parts to repair them all as well as how to instructions. Sure I can call a window replacement company but my guess is they will say nope. Yo ... (cont.)

I need a pair of these that are 3" in length with holes at 1 3/8" and 2 3/8" from the head and 3/16" deep by 5/16" wide.

Two pivot bars broke in half on my vinyl window. Trying to find the correct replacement part.

Looking for 10 to 20 pivot rods that have a defect where they break at the screw hole (closest to edge of window). Also there is the occasional break of the pivot piece (other picture) where I should get a few as well. lease let me know asap.

This piece broke off my kitchen window. When I try to open the window it will almost come off the track and fall to the floor

Hello. The picture is all I have to offer. I have to parts number. It is the part that holds the window in place. It broke off when window was tilted at too much of an angle. Hoping you can assist.

I need a bunch of replacement pivot pins for 'Regency" replacement windows. Total length is 2 3/4"

I would like assistance to purchase the correct pivot bar. Thank you for your assistance.

Surfed your catalog a bit and I think it's a #4 coil spring series 150 (#4 stamped on the top clip in picture). All the other hardware looks good. Should I order just the coil springs?

17" by 21" bathroom window. Balances are missing and/or broken. Anlin Window. Is it possible to obtain parts to repair?

Hi, The part I'm trying to identify in the picture is partially broken ... the white plastic should extend a little further upward on either side at the top of the part. The part sits in the side of the window panel and allows the window to glide up and down with ease, having a metal rod from the w ... (cont.)

We need a left and a right assembly. These are the only parts left. Not sure what is all needed.

I recently purchased two S140-10 coil balances, left and right. They went in easily, however, the existing pivot bar is to big to fit in S140-10 slots. The existing pivot bars are 1 1/4 inches long with two screw holes as shown in the picture. Can you tell me which Swisco pivot bars will fit my s ... (cont.)

This broke in half, there are two on either side of the bottom of the window where do I find this part?

Moved into a house with multiple windows broken as seen in the first photo. Determined it to be a coil balance, but it was in pieces when I got it out. I'll be honest - not sure how they got them in in the first place as there is no distinct opening in the channel to pull them out, had to pry out wi ... (cont.)

Trying to locate a replacement one of these, it comes out of a tilt window, hannasmith is the only sticker I can find, there are no glass etchings in the corners etc

I need the left and right balance assemlies for Anlin window m/n H-R30-48x96 as well as replacement tilt window sash pivot pin (3")

it has a patent #5,704,165 and uses a 7/16 to 1/2 inch coil balance

I would like a price