Viewing all customer Discussions for:

26-408 Tilt Latch Pair

Inside of latch is 8590. Windows installed by a previous owner, make is unknown.

Good afternoon, I'm trying to find a replacement finger latch, as well as 2 balances and pivots but im havimg some trouble locating the right ones. Any help would be greatly appreciated.

Can I please have the numbers for the attached parts the tilt I believe is 408

I need a couple sets of the window latch for my American Craftsman windows the bottom part of the window is the only part that tilts and locks

Look for the part information for the window tilt latch, my windows are a beige/tan color.

Hello!I am hoping someone can help me pick out the replacement parts. I need for my Silverline windows. Please excuse the dirty photographs. I tried to include the sticker that may have more model information, but admittedly it is a bit aged. The windows are probably about 15 years old. As it stan ... (cont.)

Could you recommend a replacement clip for this window. I attached photos

Thank you.

Hi am trying to track down these couple of parts for my window. 2 broken coil springs and 2 top slides broken. Help please. Thank you

The window tilt part I need to replace is completely broken.I can not just tap and slide it out the side. The part sits in a hole that is 2" long, has a space after the hole before the corner of the window of .5" where the stop would stick out after mounting (one hole to drill), and I would expect a ... (cont.)

Looking to replace the tilt window locking tabs. Please view BOVBE

For customer estimate

Replacement tilt latches needed measure 2 7/8 length, 3/4 " on short end and 1 1/2" on wide end. I am unable to locate any markings on the windows

Window tilt latches are broken , need replacement

I am searhing for the left and right hand sid piece for a tilt window. The piece is a latch that holds th window in the trak and allows you to remove the window. The piece appears to be spring loaded and slides back and forth, allowing the latch to move.

The parts are for Anderson Silver-Line windows that are 10 years old.This appears to be a combined unit (spring and shoe) where the spring has broken. The clear plastic triangle shaped piece is what holds the spring in place mid-frame.Please note the "7" on the shoe. These windows use 2 per sash; on ... (cont.)

I need to order 4 pairs of tilt latches for American Craftsman white windows that I bought in 4/9/2011. The part number for the left one is 8590. I haven't taken the right one out yet.

I will need to confirm the correct part number for the Silverline windows(Anderson) now owned by Plygem.comThanks,Bill

HI, I HAVE BEEN THROUGH MOST/ALL OF YOUR SURFACE MOUNTS AND IT DOESN'T LOOK LIKE ANY OF THE SCREW HOLES WILL ALLOW ME TO ATTACH TO THIS WINDOW. CAN YOU FIND ANY LATCHES THAT WOULD FIT PLEASE AND THANK YOU IN ADVANCE, HEIDI

I'm looking to replace the latch that secures the window in the balance for the tilted sash