Viewing all customer Discussions for:

39-411 Ware Window Crank, RH

I don't see any markings on the crank nor the windows themselves. I'm looking for replacements for both left and right.

Unfortunately there are no markings on the crank that I took off. The connecting hole is 3/8" diameter and connects to the window linkage via an "E" clip. Note the slight offset in the connecting link. There are several cranks that need replacing but I would like to start with one just to make su ... (cont.)

I need a replacement "bronze awning window right crank assembly" for PAT. NO.198202 U.S. 2 R.H. R.D.1963 CAN

Pretty sure the window is made by WARE, Miami FL. Control box is about 5.5". The box is pretty much empty. The piece that connects to the window is missing

I need several awning window operators, both LH and RH. I'm attaching a sketch with dimensions I believe are important and photos of an existing LH operator from several angles. I cannot find any identification on the windows or the operators. I thought 39-016 would be close, but it is not quite. ... (cont.)

This looks like the Pan am/Daryl operator except the two wholes to the bottom on.mine are One inch from center not

Hello! I did a quick look on your site but couldn't find awning window operator that matches the specs of the ones I have and are wanting to replace. All the measurements are on the photo. I found a similar one online and edited with the two specs on mine that are different. Any help would be appre ... (cont.)

This has an offset main linkage off gear, holes for mounting are not critical but would be nice, so as not to retap screw holes. Just ordered many window parts. the patent #198202, on swisco theres a recommendation for that # but not a good match because no offset as clearly pictured. Thank you A ... (cont.)

awning window operator with only two mounting holes. All help appreciated identifying.

I need a replacement crank. Do you have any like this?

Please can you help me we're can I get this

I need a replacement for this window crank. Attached are the dimensions I frequently see on your descriptions

looking for the right part.

OFFSET ARM 2 inch C-C 7/16 HOLE BOTTOM HOLES 1 3/8 C-C VERTICAL HOLES 5 1/4 C-C GREY I can't find markings on the window or the operator

I need replacement cranks for a few of my windows. Almost all are right hand link the one shown in the pictures but I do have a couple left. These windows were manufactured by Bass Window & Door in Princeton FL but the have been out of business for over 20 years. Please give my your part numbers ... (cont.)

Right arm awning window operator. I do not know wthe brand of the window. Windows are old.

Do you have this in a right handed?

This hardware attaches to the window frame via three screws and it's stamped with the letters "ST" as shown on the photo of the removed hardware.

Window Crank on my jalousie window will open window but not close. Window Crank has no identification on it and was connected to window hardware by a river connection. Had to drill out rivet to remove window Crank so I will need hardware to replace rivet. Thank you for your assistance. ... (cont.)

Good morning. I'm restoring the original windows in my new home. Most important part I need is the bracket, which has a broken tab. It's about 5" in length.Judging by the another set of holes in the frame the crank might not be original. I might need one going forward as I've only started with th ... (cont.)