Viewing all customer Discussions for:

33-104 Phillips 1/4-20 x 3/4" SS Machine Screw

Looking for replacement rollers for this 1950's era roller. Any assistance is appreciated. Thank you!

1-1/4" nylon wheels. 80mm total with wheel and 17mm wide at case.

These are 5 of 6 pictures I had taken. It appears to be an 1=1/2 inch steel rollerCan you help me identify a replacement roller please?Let me know if you need any more info or picturesThank you Christopher

Please see attached top, back and side photos. Unit housing width = 3/4 in. Unit housing height = 1 11/16. Wheel diameter = 1 11/16. Wheel Material is nylon. Units are attached to glass door bottom aluminum rail with drift pins. Note that the end view shows the top phillips head bolt must be the adj ... (cont.)

I need two new rollers for the PGT series 2500 sliding glass door leading to my lanai. The home was built in 2004. Can you please identify the roller assembly for me and place an order for two of them?

Good

looking to replace 10 sets of these

Trying to find these two cartridge mortise type of door roller. The rollers are plastic and in tandem like an inline skate.

Looking for replacement. Name of door company no longer on door.

Need replacement parts

I'm having a hard time finding a match for two rollers: Roller stamped A-S NYC 7867 3 5/8" long 1 3/8" tall 3/4" wide The roller is stuck inside, but the OD is appears to be 1 1/4" The brass roller has no stamps 2 1/2" long 1 1/4" tall A little over 5/8" wide OD wheel 1 1/4" Additionally, I canno ... (cont.)

We need 2 of these single 1 1/4 inch rollers. The door is 44 years old and on our boat.Thank you!John

I'll use the following terminology: vertical frame member, horizontal frame member, 4-sided bracket, 3-sided bracket, roller axle. I'm trying to describe the door in a way that makes my terminology clear. The door has a vertical frame member that runs the height of the door that seals to the glass. ... (cont.)

I looking for replacement rollers and possibly the housing as well for the attached images. The house was built in the 57 and I think the sliding glass door / sunroom was added early to mid 60's. The frame is entirely aluminum . There are 2 rollers on each door panel . Each door is 48" x 81" approx. ... (cont.)

Home built circa 2004, sliding patio door rollers are broken brand name says ultra but I can't find them anywhere.

Door is about 30 years old code pen-1 spec SGD-A2/S617

I need assistance in finding this part Please. I would need 2 pairs of these. Thank you.

Hi there. My mid-50s slider is suffering and in need of new wheels. I've searched the internet for photos of the same wheels, but no luck. The one identifying name is on the inside, but it's missing some letters so I'm not sure what the word actually is. The height adjustment on this door has to ... (cont.)

I would like to replace my patio door rollers, they are at least 20 years old at barely work; the only marking on them is "Production Enterprises Hialeah, FLA"; your site had so many options, I wasn't sure which were the correct ones; let me know if you need more information

This is the roller off a 7 foot sliding patio door that is 50-70 years old.