Viewing all customer Discussions for:

26-188 Black Metal Neutral Tilt Latch, 2-5/16"

Please help me find a replacement. The measurement from center screw to center screw is 2 and 1/4 inches.

hi -- this looks to be a tilt dash for an aluminum double hung window. Seems to measure 2-3/8 center to center but maybe it's really 2-5/16.

I am looking to replace this part on a few windows.

Hi - can you help me identify the part needed? Thanks!

I don't see any numbers on it. But the piece that goes into the window is broken so the window isn't closing properly. I took measurements their a little off but it's 1 1/8 and a hair over x 3 1/4 it's a little close to the 3/8 on my measuring tape. Hope this helps

The windows are from "Champion Window". This company told me that the windows are of industrial grade (sold to a real-estate developer) and about 20 years old. The company cannot provide the parts. The 3 type of parts I need are shown in the attached photo. For a preliminary test I need: (1) Left & ... (cont.)

Hi, I'm wondering if you can help identify this tilt latch. It slides into a groove in the top of the window and then the thumb slider snaps into place from above. To the best of my knowledge the windows were manufactured around 1990. They are double paned with aluminum frames. Thanks! ... (cont.)

we have Champion window, maybe 10 years old and need inside latch for tilt windows very much like your part 26-345 exceptours measures 1.375 inches by 3.375 inches Black

hello, i just have a question about the black tilt latch. im not sure exactly what neural/reversible tilt latch mean? would i have to kinda switch the insides to fit either left or right? please let me know what exactly what this means. i need lefts and rights. thank you

bOTH OF THE TABS THAT HOLD THE WINDOW SHUT SNAPPED OFF. THE ONLY NUMBER ON EITHER SIDE OF IT IS THE NUMBER 4. Can you help ?

Where do I find this part and is it easy to replace.

Distant between screws 2:1/4 W is 1:1/8 Length 3:5/16

The measurements are... 2 3/8 long, 3/4 wide, 3/8 tall, and 2 1/16 from center of screw hole to edge of window. There is only 1 screw hole. I would prefer metal, but black is the only must. The windows are black aluminum. I'm not opposed to drilling another screw hole, if needed. ... (cont.)

Looking to identify all the parts on my window that could be replaced myself. A contractor quoted replacing spiral balances and gear mechanisms?

Hi Tom,I recently purchased 2- 26-188 tilt latches that look like what i have but they do not match up so after measuring the 26-215 will work but do you have them in dark brown or black. Thank you Dave

This is a Champion Window, these latches are for the sliding lower part of the window system. I measured the longer side of this rectangular as 3 3/8'' Does this 26-188 fit for sure?

Back in 1997 we did a renovation which included all new windows.... they are ALL wood frame and sash... single (lower) hung & tilt mechanism So, here are the following main issues I have.... First main issue is the PLASTIC tubing around the spiral balances have dried up, cracked, disintegra ... (cont.)

Hi there, I'm hoping you might be able to help me. As you'll see from the attached, I'm looking for the latch piece that allows the window to swing in and out vertically for cleaning (not the security lock). Sorry if I'm using the wrong terminology. It's from a Champion window, and may or ma ... (cont.)

Is the entire tilt latch made out of steel? Meaning is there no plastic or vinyl on the latch