Viewing all customer Discussions for:

82-265 Multi-Point Mortise Lock with Face Plate, 11"

Only see mark "Pat Pend"

Do you sell anything that could change the height of the keeper/strike plate? See picture. The old keeper plate is higher then new one. The door does not reach the keeper plate. Do you have anything that would make the keeper plate further out from wall so the door mortise lock can latch to keeper p ... (cont.)

Hello everyone I need some help with some parts for a sliding door if you could take a look at these photos and I'll be needing the strike for that double motors lock and I want track that can go down into the track part you'll see in the picture

Will doorkeeper part number 82-249 work with mortise lock with face plate part number 82 -265?

Looking for replacement parts for this type of guardian door: Guardian Corsicana Tex 15 CFR 1201 II ANSI Z97 1-2015 SGCC 1248 1/8UA 3.0 MM CAN/CGSB-12.1 M90 Thanks!!!

Looking for sliding door lock mechanism ours has jammed.

I measured: 11 inches on door portion with claws from top screw to bottom screw 3 inches for middle screws 7 1/2 for claws or fingers that come out 4 inches for the screws on the inside of house side

I need to order a part for my silver line sliding glass door. The door latch won't stay in the open position. This causes the door to latch and inadvertently lock the door. Can I order a replacement part for this?

Can you help me identify these parts. I have never seen this type of roller before. Thank you in advance

the top portion of the double lock is stuck in the lock position, the bottom still works. I need part number for replacement lock mechanism. thank you

One of the hooks are broke This one looks like it will work. Total measurement is 11 and five eights with 11 inch center screws I could probably use the old handles that I would like to send you pictures of both. Thank you very much.

My door doesn't close smoothly, I have to push back and forth a little in order to lock it, I tried to adjust it, but I couldn't,

Hello, I had previously ordered 82-249 and 82-265 but the faceplate (82-249) does not line up correctly with 82 -249. I have enclosed pictures of the old lock and faceplate. I also attach a photo of 82-265 installed in the slider and it seems to fit perfectly. The problem is 82-249 is not lining ... (cont.)

Hi. Can you please identify what lock latch system we must buy to replace our broken latch lock system. 404-664-8613. Thank you

Hi, we need to replace the mortise on our patio door. The attached image shows the dimensions. The face plate is 10" on center between the top and bottom screws. The mortise has 4" length between the interior screw holes and has two latches. It accepts a Schlage SC1 KIK.Could you give me a repla ... (cont.)

Need 2 sets of sliding glass door handles and locks SILVERLINE MARTELL 2 hd 295-848 pd mortise lock 2 11-PM526A GEMINI 2 POINT LOCK W/COVER PLATE

The bottom latch of the lock stopped working. It won't move when trying to lock the door manually or with a key. Only moves once I pull on the bottom latch. Any idea what's wrong or how to fix the issue?

The handle and lock is for an exterior patio door. It is on a Reliabilt sliding glass door, sold at lowes.The upper claw latch first quit latching many months ago. Then after repeated abuse from the littles in our house the thin aluminum gave way on the handle.The measurements are as follows:Handle: ... (cont.)

Hi I was wondering what type of lock i will need to replace this broken one?

There are no labels, #'s etc.