Viewing all customer Discussions for:

82-265 Multi-Point Mortise Lock with Face Plate, 11"

Can't seem to figure out replacement of a locking lever. 82-107 and 82-265. The long tab that fits into the latch mechanism has a wider part. Does that fit into the 82-107 or into the mortise latch mechanism from the other side. I can't seem to figure out why it wouldn't just fall out. What is keepi ... (cont.)

Good morning I sent two photos of a double latch that I need. They are mounted in sliding doors. Also are there any lock cylinders that can be rekeyed for Schlage keys?

How to adjust. When I close the door and activate the lock I must pull the door back slightly to properly engage. If not it appears to lock but isn't.

I would like to identify this latch. The locking lever is broken so I probably need the mortise lock and handle with the locking lever. Can you help? On the mortise I see PD 0020. Thanks

Need new need help lol

We have 50 units with sliding glass doors. Some of the latches lock when a user steps onto their deck, locking them out. This is a problem, especially since some of our residents are in their 80s and live on the third floor. I have received your 82-265 Mortice lock. It fits the opening in the door p ... (cont.)

the part on my door is white. do you have it in white also?

To Whom it May Concern, I just bought my house and have a few missing parts to my sliding glass door. I am missing the outside handle and the internal locking mechanism. Can you please help.I have enclosed some pictures. Thanks, Scott

I just want to confirm you 82-265 is the same. Please note how my lock engages the other way. Not sure if it matters.

It's for a sliding door Measurements fastener to fastener 11" Measurement from end to end 11-3/4" Let me know what you recommend.

I have a hurricane sliding glass door. The latch has broken. The top and bottom screw holes are 11 inches apart. Can you please help me replace.

Is keeper 82-249 a match for lock 82-265? Thanks!

Has the part number PM520A (part of a Atrium Sliding Glass Door locking mechanism)been replaced by something else. I am missing this part and I can?t seem to get the part number to come up anywhere! Can anyone help locate this part or part number please?

I have a fuhr lock on patio doors one side the handle moves about a a third of the way before the latch comes out and the dead bolt on that side doesn't work with knob or key wEnt on fuhr site for US only contact was in Germany? Local service contact cell 717-951-3839

Made 12/20/13 in Taiwan QC OASS 2777-00 PAT # 6.264.252 and PAT #5.820.170 10"x 1/2" x 1 1/16

I need to order two (2) mortised hook latches to fit the attached keeper. Can you determine if I need the 82-239 of the 82-265 based on this keeper (and thumb turn) Thanks, Fred

Hi, my mortise 2 point lock is broken and I want to replace it. My problem is getting the mortise lock out. Do I have to remove the entire door off the track? I tried to pry it out with a flat head screw driver but it is slightly larger than the hole. I see from one viewer you do not have the 10” m ... (cont.)

I ordered this lock and the lock itself fits and works but when I put the face plate the lock won

I think this is a Mortise 82-265. What say you?

I am not sure where to find this part. I checked the site but didn't find any part matching the total length of this piece. Can you please help?