Viewing all customer Discussions for:

26-226 Pivot Bar, 3-1/16"

we have a broken metal end on one of our windows. I like to order two if possible.Mark

Good Morning,We have a few windows that have broken pivot bars. The first picture is what the windows look like. They were installed 13 years ago. I took a picture of one of the broken pivots. There is a #5 etched into it.I really hope you can help us. We are moving and the inspector is not going to ... (cont.)

Pivot shoe and bar for Harvey double hung spring balanc with a hook

Looking for part identification and place to purchase the parts for Alside double hung tilt windows.

I have bought before parts for our windows. Do you recognize this part. It belongs to the same windows I have bought parts before.Looking forward to your helpSincerely Isaac T

It is 3 1/8" long distance between holes1" and 1 1/4"from head to first hole

I need 4 these pivot bars ASAP make that for just in case

looking for replacements

Hi I am looking for a pair of replacement pivot pins for a double hung sash. The dimensions are: 2-3/4" long, 1-7/16" to center of hole. (measurements taken from end to end). The shaft measurements are 3/16" x 1/4". The 2 part numbers that seem close are 26-030 and 26-226. Total over all length will ... (cont.)

I've attached pictures of the broken and good cams, and the part of the windows that fits into them. I can't find any writing on the windows or parts, or figure out how to remove the broken parts. They are spring loaded to help open the window, but when the window tilts out it rotates the cams cau ... (cont.)

Two of the pictures show the part that broke off. The last one shows the holes for the screws to hold the pin. Thank you for your help. I sent a separate email. Edited finding this asking how to send pictures.

Hello, Please help, I am looking to replace broken pivot pins for the bottom sash of my window. the pin has a number 2 on it but is 2 3/4 inches long. The plastic piece it slides into is still good, however if it is sold as a kit I will take both. I need one for each side of the window (2 total) ... (cont.)

2 3/4" OAL 1 3/8" to first hole 2 1/8" to second hole

I am looking for this pivot bar 2/12 long it looks like the Center of the threaded screw hole is 11/4 in from the end it looks like 1/4 in wide if you can locate them I need 8 of them thank you

Pins appear to be aluminum, there is a circle on one side of the pin near the rounded end with a number 1 inside the circle. I'm not sure age of windows? - 2-3/4" long - top to middle of screw hole- 1-1/8"

I need to purchase 10 of these window anchors to replace broken ones. I do not have any information on what type of window it is.

Looking for this part for a ComfortWorld window. I'm not sure why the photograph makes the pivot pin look like it's only 3 inches because it is actually about 3 1/8 inch long.

Spiral balance vinyl window slide/tilt key

Looking for pivot bars for my Alside vinyl replacement windows, photo attached

Hello. A big wind storm blew our window out couple months ago. It appears that the hinges on top and inside the frame are gone. The photo with the two little metal pieces and pieces of plastic was all that was on the floor after the windstorm. Are these parts replaceable? And if so how much will the ... (cont.)