Viewing all customer Discussions for:

26-241 Pivot Bar, 3"

I have a number of windows with broken pivot bars. I also am unsure as to how to. Re-install window sashes once new bars are obtained

Looking for Pivot bar and slide block to mount window into . Window is from Window Wizard over 15 years ago. I suspect replacement bar is your part number 26-241. The side block I can't determine on your web site. I provided W Wizards window part number label for reference. Also can you recommend b ... (cont.)

Hi, I can't find these L shaped bars and wanted to know if I could just use straight bars instead.

Need to find replacement parts for coil balance and pivot bars for simmonton tilt window. Please see attached photos. There ar no marking on any of the parts or the window.

Good afternoon, I am trying to locate some parts for these windows, they are original to the house around 1999. I don't know the brand. The block and tackle assembly pieces are broken as well as some bottom pivot bars. The plastic piece that attaches the spring to the pulley system is where the inte ... (cont.)

Need one of these. It looks like the two screw holes that are used are 3/4" apart (at 1 1/4" and at 2").

Hi, I have 7 windows in my house that do not stay open. The house is 24 years old. Only one balance is still together. I took it out of window, see attached photos. The only marks on it is "PAT. PEND." Top to bottom it is almost 29" and the part that was attached to the window is 1 3/8" wide. The wi ... (cont.)

Looking for a few parts that sit below the window

I am looking for the parts to repair the windows in my condominium. The counter balance spring has a part # 1620 f stamped on it. The spring is 17 inches long. It appears the problem is the attachment of the spring at the bottom of the window. The condo is near the ocean and it looks like the nylon ... (cont.)

Trying to find some carefree tilt sash pins

what parts do I need? Part Number do you think? The post shown is 3" in length and about 1/4" width. I'm not sure what the other end inside the sash looks like. Can you inform me of what part I need to order?

Trying to locate this Pivot shoe for a tilt window,the little piece that attaches the balance rod has broken off the top,like a little hook if you will....thanks so much in advance for you time!

Need replacement pivot pin for the 3 inch pins shown in place in 2 photos. Third picture shows broken pin fragment for which I need a full replacement and three spares.

The lower sash of the window that was installed 10/14/2004 won't stay up. I have taken off the lower window and the coils on both sides are all coiled up on the bottom. I can't figure out what company made the window. The coils look very different than all the YouTubes videos I've watched to get ... (cont.)

Can't locate this bar in 2 1/2". I saw 3". Can you assist me ?

Tilt window block and tackle balance bar with a screw at the top. I believe it is for American Craftsman double tilt window. The code on the bar is 25C BSI or L. The bar is 25" long.I also need the balance shoe (2 of these)

I have Sunrise double hung wood windows (double paned) and I need 6 pairs of the lower pivot bars. I saw some similar replacements but nothing identical on my Google search. Thanks!

their are no numbers on the pivot bar

Hi, Need to replace pivot bars on most of my windows. I would be looking for 10 sets or 20 bars. I do know this is 3" long and L-shaped.

Hi, Need to replace pivot bars on most of my windows. I would be looking for 10 sets or 20 bars. I do know this is 3" long and L-shaped.