Viewing all customer Discussions for:

32-020 Corner Glide

Need this plastic piece that guide draw one on each side thank you

Looking to repair/replace parts for drawer. Have 10 drawers. Degree of difficulty to replace ? Noticed original is stapled, is that the only option to secure ?

Need for reburbished piece

what is the material of this guide? Is it soft enough to put a staple thru it like nylon or will it crack?

Two parts are missing from some of the drawers in my unfinished bureaus that I would like to paint. 4 Corner guide pcs. Needed (was told by co. Where I originally purchased bureaus that fir corner pcs I will need to improvise by using part #32-020. 2 Center plastic pcs. Needed

Trying to locate a replacement as two drawer dresser is missing one.

Can you please tell me what the white L shape is so that I can order parts accurately? Do I need this part?

Flat rectangular tack glide , I purchased the round ones but they?re too thick

I've found 2 of the above pictures through google the other is the actual picture of one of the parts on the bottom of the drawer. The white colored plastic one led me to your website. It is on a Harrison Furniture dresser and night stand 1 1/8 inch wide on track. It slides on a wooden track attac ... (cont.)

Hello, I need 10 of these little buggers. They are made of plastic / nylon. It's a little molded L shape with a pin molded into it. The pin rests in a hole in the cabinet rail to hold it in place. Without these, the drawers don't come in and out smoothly and don't sit at the right height. The sink ... (cont.)

need to know thickness of slide pad

I'm looking for a side saddle glide with a stud instead of an integral tack (your #: 32-083) or staples (your #: 32-020) to affix it. The long part of the 'L' is ~3/4", and the short part is 1/2". The stud is ~5/8"-6/8"in diameter and 1/2" long. It's marked 'REISS'. The corresponding back glid ... (cont.)

Hello ... I'm trying to purchase drawer clips for a Childchaft bureau purchased in 1991. I made an attempt to get clips, but unfortunately the wrong clips were sent to me. I'm in the process of returning.

I bought this bureau from Jordan's Furniture about 20 years ago. One of the plastic pieces in the top drawer slot (left corner) broke and now the drawer falls out when I pull out the drawer unless I'm really careful not to pull it out too far. It looks like I just need that small square piece to be ... (cont.)

Have 1 inch wood rails in good shape. 16" length. Center mount . Could use front &. Rear SWISCO type brackets or 16" length pieces. That would attach to bottom of each drawer . Can you help me out.?

Hi - looking for the attached part. Thanks!

Opening between the two tabs is one inch. Bottom part goes in groove in dresser. Tabs are 1/2 inch tall.

Looking for these two drawer guides that go on either side of my drawers.

Can screw caps work on both ends of a screw? Do you have heat shields for screws?

My corner glides on the dresser are broken do you sell them? Or where can you get them??