Viewing all customer Discussions for:

39-253LB Encore Dual Arm Operator, Sill Mount

Can you tell me if your folding crank handle Product Code: 39-375 would be a direct replacement for the crank handle above. Looking to replace our cranks with nesting cranks so the handles dont walk off. Our current handles don't have a set screw they just snap/pull on and off. Also curious how y ... (cont.)

I can not find a window manufacture on the window - the travel guide on the bottom of the window sash is pictured the arm appears to insert in the black guide - I can't figure out how it is retained or if there is a piece missing or where to find parts

These are on Gorell casement windows that were installed about 15 years ago. Are there replacements available

White plastic, this crank is on left side of window. The only markings on it are the brand "TRUTH"

I have two windows not closing properly. One will not close far enough to use lock mechanism, the other window will shut on the lock side but the far side pushes away from sill.Once we figure out what I need I would like to by two sets of hardware. If I get them installed properly I'll probably buy ... (cont.)

I have Acan crank out windows in one of my rentals and the cranks are broken how do I find the right one that I need

Hellow swisco. I am looking for parts and have included a pic of parts and a list of parts from your site. If someone could look them over and give me some other parts that would go along with it and confirm the list I would appreciate it thanks.

Hi please advise which mechanism needs to be purchased. The window will open and close but will not fully close the last inch or so. Thanks Jerry S.

Yesterday, I tried to install my encore dual arm and discovered that the pin at the end of the long arm on the new part (see first picture) is just a tad smaller than the pin on the old existing part. When I try to insert the pin into the holder hole at the bottom of the existing window, the pin do ... (cont.)

One window has only a broken handle to the crank. The other window the crank isn't attached to the window.

vinyl casement windows operator would need a price for a left and right

I missing the glide that connects the arm to the window. Not sure if that makes sense. I have included a photo of the glide from another window. The glide should fit on the arm that isn't latching to the actual window. When I crank the window the arm doesn't remain attached to the window because the ... (cont.)

Hello, My window operator won't fully close the window, I think the teeth are damaged. Can you identify this model? I couldn't find any manufacturer markings on the window. Thank you.

Can you identify and provide a replacement for this window crank. I need one as shown in the pictures and one that is the reverse of that crank. Thanks so much.

Need to replace this HURD kitchen window actuator. Gear mechanism is worn out preventing window from completely closing.

arm operator

I am looking for 4 of these.

Hi, I'm wondering if the casement window operator (in the attached picture) can be replaced with a Maxim Dual Arm Operator, Sill Mount (39-253L)?

please let me know where I can get this part? thank you!

I have 2 windows that need same part. Left and Right handle side. These windows are on the sides of my large picture window in living room.