Viewing all customer Discussions for:

39-439B Encore Dual Arm Operator, Sill Mount, Low Profile

HelloI have some old Bonneville casement windows that need hinges and operators replacedI need 8 hinges (see picture) and one set of left and right-hand operators for both operator types. By inside of elbow on notes I mean where the interior bend in the arm starts from the long end (not the gear end ... (cont.)

Hi Swisco - attached photos show our bathroom casement window, with crank opener mechanism. Window was installed in 2001. I am not sure what brand was used by the contractor - maybe the label helps? I removed some corrosion a few years ago and spray-painted the mechanism (beige), but it looks like ... (cont.)

I will send photos. Let me know what else you need. I believe it is a Truth Hardware Encore operator.

I have two PGT Windows (CA5540) that are not operating. It seems to be an issue with the operating mechanism (the "hinge" if you want to call it that).

hello! I am a homeowner. bought house 6 months ago. can't find stickers, etching or anything to identify window brand. numbers on hardware: 9D501 and 9DD00P. please help. THANK YOU!!

Looking to replace four Thermal-Gard Truth casement cranks. Can you please help me identify the replacement part number. Thank you.

Hi I need a replacement part for my window. When I crank the crank it works fine until the very end where it just slips and won't close. There seems to be some teeth on the gear that are worn down that perhaps is leading to this slipping.

It is the rusted bracket that is attached to the bottom of the window and the plastic slider part on the window sill. The track on the sill is about 10" long. The track on the window is about 8" long. Also it is on a left hand window.

I need to replace the hardware for this crank. The gears are stripped at and it will not pull the window closed. Having a hard time finding anything that matches because the handle is on the left hand side.

I needthe operator assemblies LH and RH for my casement windows that open in opposite directions, They are stamped TRUTH on one of the arms.Notice that on one window there is number 40986 stamped for RH side and 40987 stamped on LH side.Louis

Hello, I have several Milgard crank windows that need replacement parts. A couple need new lock assemblies and a few need, I think, new arm operators. When the crank is used, the window stops short of closing. Would you be able to tell me which parts I need?

Goof day, I am looking to replace all hardware for this casement window. It is a 24w x 48h casement window

Photo of Hurd Casement arm. Need a left and right. Gears are not engaging to be able to open/shut. Sorry for the delay "life" got in way of our project.

hi. I need various parts to replace. I noticed that some of the reasons for the windows being damaged are small plastic parts have become brittle and have fallen off causing part to come out of track.

Looking for window crank to fit this window.

We have a control mechanism for opening or closing a window where the gears teeth have been broken. Also on a separate window, we have locking arm that has been broken off

I'm looking for new hardware to replace these older units. Needs to sit simular on the frames.

Need new operator

I need the following part, looks like EntryGard Dual Arm Operator Product Code: 39-031. I believe my window swings left (please see photo)? I have 3 other photos I'll send in the next email. You can see it says "Truth" and a # of 41012. Thx, Drissana

Hi, I've looked all over and can't find any names or markings on these parts. I'm looking to replace the crank and operator set. The screw must be stripped and the crank doesn't work and one of the swing arms just comes off.