Viewing all customer Discussions for:

33-067 3/8" Shoulder Screw, 5/16"-18 Thread

Crank just spins and Spins window doesn't open or closed

Wondering if the 39-056 is a suitable replacement. Thank you, Robert

i purchased the 39-012 Superior window crank.pictured below is the female receptacle located on the far right side of the old window arm into which you screw in either the 39-074 or 33-067 screw.i need this female piece as the one that is on the original arm attached to the old window crank arm is f ... (cont.)

No markings Old aluminum double window Glass is glazed in

Hello, I have a house with many of these operators that need to be replaced. Your help identifying the correct part is greatly appreciated. There is no brand name or info anywhere to be found on the window. The photos attached show what I can see and measurements are there. Please let me know i ... (cont.)

I have LOOK window cranks. I need replacement crank and the screws to muon to the casing. thanks kenny

Looking for pins or rivets for old style casement windows hingesi only need 4 pins or rivets I ground the tops off so I could remove windows to replace glass thinking it would be easy to replace the hinge hardware. But not so easy. The rivets must be installed at the factory when making the windows ... (cont.)

Hello. Hopefully you can help. My wife and I live in a condo in Honolulu?Villa At Eaton Square. I am attaching two photos. I need to purchase one window crank. Can you tell from the photos which one we need (I saw a reference to a 016, and a 017, but I don?t know which is correct)? Thank you ... (cont.)

Missing female for part 33-067. Ordered part 39-074, 33-067 but I need the female for the screw of part 33-067. Can you help?

There are no markings at all on the crank assembly. It came off a Jalousie type window. Any help would be appreciated. If you have them, I would buy them from you. I need around 8 or 9. They are for my sons sun room windows off the back of his house.

Please let me know what other photo angles or information I can provide.Measurements:casing: 150mm X 50mm X 25mmtwo hole base: 59mm X 22 mm, screw holes 7mmswivel arm: 69mm X 15mm, hole diameter 12mm.

Part for an old jealousy/awning window

Hi! I recently bought a house built in 1969 and I think the crank may be original. It is a Pan Am and it might be 6007 for numbers on it. The crank part does not close the window now and I'm trying to replacing the entire crank so that I can operate the window. It is a right side window crank.I obta ... (cont.)

I need 1/4"-28 shoulder bolts and plastic bushings for Woodco window crank arms.

I, too, have LEMCO Series 30 awning windows. I am looking for the LEFT HAND crank.

I need to know the correct replacement part ro order.

Hi, I have awning windows that are stamped/branded Pan Am, I uploaded a few pictures of the cranks that they used could you look at the picks and advise what type of replacements you have that could be used?

Good afternoon, I'm looking for two left hand crank assemblies to replace the type shown in the attached photos and drawing. I can send more if needed. Windows are circa 1979, all aluminum.

There is a number 73 on the bar.

I've been searching for a replacement window operator like the one shown in the attached photos. No luck. There are no names or numbers on the operator or window frame. I can probably mount an operator that doesn't have the lower dogleg and can transfer the old connecting link to a new operator ... (cont.)