Viewing all customer Discussions for:

39-032 EntryGard Dual Arm Operator

I need a replacement crank gear for a 26" x 35" Cantilever window. I believe it's a Caradco window and it is marked "Entry Guard II Truth 20755". Thanks so much.

There are no markings but the part is on the bottom of the window pane as shown in pictures. The windows were Marvin windows probably manufactured early 80s. Marvin.com said they discontinued that part and advised me to check with you guys.

Looking to replace the window cranks on a few windows in the house that don't operate any more. The house was built in the late 80s and with cranks say K&K it looks like. They also say Entrygard Truth and some numbers 20810, R30842. Those number can be found in the pictures I sent over. The pic ... (cont.)

Looks like a 7" shaft and a center operating crank handle.Questions/ call

Do you have this replacement

I am looking to replace the operator above. Can you point me in the right direction?

Do you need any additional Info? do I need measurements of anything? Windo size arm length???

I tried opening a left bathroom window that had not been open in years. Apparently I used too much force and snapped the bottom arm. I cannot find Vetter replacement parts on Amazon. Are there standard replacement parts for these operators?

After a big storm and -20 degree weather for a few days the crank no longer opens the window. It feels like a gear is turning over. But the part has the following text visible to me "made in the USA" "48" and "90"or"06" can't tell which one. But is this part from you guys? If not do yo ... (cont.)

Looking for the crank mechanism and arm for this left and right. Also the accompanying lock and bar for the right. Thanks

Can this handle replace existing handle on 39-031 and 39-032 dual arm operators? Bob

The arm operator on my window operator sheered off and no longer works. I'm looking to replace it. Not sure which operator is the right replacement piece. And then also, the eye hooks on the window that would act as the locking mechanism on the actual window is missing.

Windows are developing a bit of rust on arms at bottom, though the big issue is corroded lower slide shoes that disengage from the hinge and then jam the windows to prevent proper closure. Would like to see if you can identify the parts we should order based on these photos. All I could identify on ... (cont.)

Hello, I am missing a couple parts for a window that I have. I am sending a couple of photos one of the window that's missing the parts and another one that has the parts. The window has a manufacturer code of ELL-1 and series 800/850Thank you

Hello,I'm looking for a replacement for the part pictured above. It is marked "Truth Hardware", "Entry Guard". Short arm has stamp 20810. The long arm is 10 1/2", and the short arm is 4 1/2". Would you have anything like it?Thanks!Brian

Can you tell me the make of this operator. I have 6 to replaceThanks Larry

casement window crank plastic outer assembly cracked

Hello, I recently purchased part # 39-032. I need the bracket to attach to the window. I accidentally threw it away.

My k&k window cranks and latches. Please identify part to order.

Has stamps as seen In attached pics Truth entry guard one looks like it's 30842R for right side? L30841 for left? Also had the numbers 20810 stamped on it. Need five sets of left and right replacements please advise.