Viewing all customer Discussions for:

Door & Window

Hello. I am looking for replacement rollers for my Alenco Sliding Glass Doors. Please see the attached photos and for label. Please help if you can. Thank you.

Hello, The worm gear that turns the cogs to open/close the window has become dislodged from its base. I see that there are matching grooves on the side of the worm gear housing and the internal aspect of the base. Can these two parts be put back together again by applying force to the worm gear t ... (cont.)

Looking for white crank handle. Number on inside is 2119R1

Need to find this part for a window need 5 of them

Hello. I'm needing these parts and would appreciate your help. Thanks, JC

looking to replace 3 pairs of tilt latches. The original shown has a patent # shown.

I need window channel balance that broke a few days ago. I can't find anywhere, I would appreciate your help with this issue. Thank you so much. Dali

Seems like they are three springs per side

Hello, Trying to find this sash clip or one that will work as a replacement. Thanks, Wesley

markings: 26 4 LW CMC 11

Hi, can you please help Id this part for replacement? Thanks

I need a replacement crank for my window

I have a casement window that needs the dual arm operator replaced (truth entryguard 30744). The window swings out and to the left + has the crank in the center (not the type that folds down). Can you tell me the correct replacement part?

24" (excluding plastic parts). Visible. marking is 24-2, then tiny letters of "BSI." Please ID and thank you!! Ingrid

Needed for right and left side

See pics. Alenco glass doors SGD-B1 Series 550, 650. Need Door Roller part numbers identified and replacement parts ordering information.

looking for a right hand and left hand gizmo that opens and closes a large anderson window. Installed @ 2010. It is 17 5/8 inch long. See picture attached. In the picture it is the long piece in the middle of the picture (still attached to the ratchet type handle) and not the lower piece (that wa ... (cont.)

Was asked by chat to post it here. Need to identify . Width seems to be 5/8

Good morning, Could you help me with identifying these parts. I have tried over an hour on Friday. Best regards

Pella windows, installed 1992. Looking for replacement crank mechanism.