Viewing all customer Discussions for:

Door & Window

I've uploaded two pics- one of the part of the window that is broken (the plastic part attached to the top of the window) and a pic of what it should look like. I was going to order the 5/8" Top Sash Guide. Do you think this is the right part?

Looking to replace channel balances in several of my windows. Stamp is 20 4 CL Caldwell. Metal measures 21 inches. Plastic ends both have wings. Channel depth is 5/8' and width is 1/2". I believe I know what I need (21" Series 380 Channel Balance, S380-21) but would like to be sure before orde ... (cont.)

Hi, I've looked all over and can't find any names or markings on these parts. I'm looking to replace the crank and operator set. The screw must be stripped and the crank doesn't work and one of the swing arms just comes off.

I need to replace the old Handle & Latch on my Chamberdoor Storm Door

Hello, I have two of these windows that no longer close properly. Any advice is welcome, thank you. Hello and thanks for the response. I'll answer as best I can. 1. 21 15/16 inches for the metal 2. Non-tilt, it's a single hung vertical slider 3. The stamp reads: 21 D B.S.I 4. 1/2 inch width 5. ... (cont.)

Twin Seal windows in home I just bought. The channel balance is 23 and 1/2 in. The boot is one and 1/8 in. The sash weighs 14 and a half pounds.

hi, here are the dimensions : window size : 39" width x 27" height operator arm length (2x) : 14" slide bar (affixed to lower inside of window) : 35"

Hi, I need 2 left and 3 right opening cranks of this type. SuperVision/Truth. Are 39-013 and 39-014 the correct operators? thank you

How to find the right date of crank & left or right crank window

1. I found the crank part. 2. The hinges are 13 inches long and I can only find 10 inch long ones. 3. the handles and crank covers are ok. i dont need new ones of those. thanks!

15.4 lbs window. 43cm x 1.3cm measured metal end to end and width of channel on the side with serial marking. 86 16-5 cmc 1 One of the side balances for the window broke at the string and hook connection on the bottom. It also appears that the wings on the plastic ends for the broken one were shear ... (cont.)

No part numbers found. Please let me know if you need more information . Thank you

Hello. I am looking to replace the lever handles only. The locking mechanism works fine. The exterior levers' finish is degraded. Do you carry these?

Trying to figure out which pivot bars & balances I need for this window. Thanks

Hello. This piece of plastic snaps into the top of my vertical sliding window. The brand is milgard. It prevents the window from opening too far. I believe its called a sash stop, but I'm not certain of that. Its 1 1/2 inches wide. It has small "hooks" on the edges that I tried to get into the photo ... (cont.)

Hi I am trying to find this window roller with plastic housing I'm having a hard time because it doesn't have a brand or numbers that I can use to look up pls help. Thank you.

I am looking to replace the springs and tilt latches on some of the windows in a town home we purchased. I am hoping the sticker will give you an idea in what and where I can purchase them. I tried to get pictures of the spring and shoe mechanisms.

Please let me know which I should order, need at least 6, possibly more. Thanks.

Hi - the lock on our window is broken, I believe they are Anderson windows circa 2005-2007

Hi, I need to replace a pair of these tilt window sash locks.