Viewing all customer Discussions for:

Door & Window

Needing help identifying the correct glazing strip replacements to order. I did not get pictures of the glazing installed, but can in the next few days. They are older aluminum non-tilting sashes.

Hi, I have thus Truth 30905 duel arm casement window. Its arm needs to be connected to the window and I need that stud bracket. Please advise the correct part to order. Thanks.

I need 6 window balances, complete set. Alenco windows 1986. The metal track is 28" long, width is half inch. The weight of the window is 20.2 pounds. The number stamped on the side is 27C. Hope you can help me. Thank you.

no name on crank looking for new crank handle also i need the window track plastic slider (about 4 of them) the lower right plastic slider for the slider broke. I was trying to figure out why the window will not close enough to lock it closed. only closes to about 3 inches then stops cranking before ... (cont.)

Hi there, I need two of these springs can you all help me identify what to purchase

Need right hand side

Hi, Need to replace the coils on our Milgard V400. The pictures are of the onesI just took out of one side (the other is a tangled mess and writing you first!). The sash weighs 28#. Are the above 2 9#? Then I'm thinking they're too strong for the window? Can you please recommend replacements? 1/2in ... (cont.)

Hello, Can you help me find a replacement? It's about 22 years old and I don't see any manufacturer or model number.

1/2" wide balances with 21 C stamped on the surface of the old balances.

Hi! Can you please help identify the latch on my window from newpro. One side broke and need to replace it.

Work for an apartment complex built around 1973, having trouble sourcing replacements, since replacing all the windows on property isn't feasible currently (approx. 850-950 on property, half of which need the beading), we've been trying to find a more secure solution with no luck. ... (cont.)

Hi Support Team - Please open a new ticket for this window part replacement. This is a separate window from the other request I have open. We need to replace the window hinge and operator. Thank you!

Identify please.

Please see attached

I need four of these rollers to replace the ones in my two sliding patio doors. Notice how the arms for the screws bend down a bit, and are not flush like most others.

Good afternoon.I have standard Tubelite commercial doors.4 sets of double doors and 1 single door. Weather stripping has never been replaced, and I need to complete this project.Please advise on what I need to get this done, and thank you in advance!

Hi there, can you help me figure out what part I need? This is a Milgard window. I believe the part we need is called an "operator". It is completely rusted/frozen/locked up in place. We may have stripped the crank, it turns freely but does nothing. I am an unskilled homeowner, but am planning to hi ... (cont.)

One tilt window in home identical to this one is missing its pivot shoes. No visible markings or branding could be determined anywhere on the window

Handle 6 1/2 " between screws

Hi - I have windows that won't stay up, and after watching a lot of videos, I think these are coil balance windows where the coils have broken. I weighed the sash and it's 14 pounds. There isn't a cutout for easy removal of the part, so I guess I'm going to need to make one, but I wanted to be sure ... (cont.)