Viewing all customer Discussions for:

Door & Window

Hello, I'm a handymanI have customer with huge heavy mirrored closets - the top guide is 4013-2 - has a vinyl rectangle that sits in the track - I can't find any replacement parts for these - do you guys have or suggest a replacement?

I am looking for a replacement for the snap-in glazing for my YKK window. It looks like it blew off and got damaged. I've added the best pictures I could get of it with a ruler and where it was on the window. Looks like it is roughly 7/8" high by 3/8" deep.

Long arm is stamped "entry gard." Shorter arms are stamped 20755 and 51538

I have windows and one of the windows can not stay lifted, and I think it has broken laches on the sides - see the picture pls.window model number is provided in the uploaded picture.csn you let me know what I need to order in order to fix it?thank you Ismet

I am looking for Pella window balances the only marking I see us 28c BSI. My existing balance has a clip on the end not a screw hole.

5 is the only marking on the pin. Uploaded the window information sticker, hopefully that helps.

I need replacement cranks for these 4 windows.....also a bag of those small parts that go in the arms. Can you identify?

I'm trying to confirm the replacement part needed for the roller wheel for a sliding door. Here are some key dimensions (casement is strel and is 3: long x 1 1/8" wide x 5/8" . There are two wheel which have a center channel. bottom wheel is 1 inch in diameter. There is one screw in the top of the c ... (cont.)

Unsure what happened to my right side assembly, one of the coils slipped out of the housing. One coil has "#90 35" " marked on it, another has "10.0" and "3" marked on it.

where can i get replacement clips

Looking to identify and replace the attached awning window operator and crank. Each arm is 9" in length. Do you know what part this is, and do you carry it?

Need balancer things with metal ribbons and a metal T part that's broken.

This is from a bathroom window. 23"x20". The lower sash weighs 10 lbs.

Hi. I have an american standard sliding glass door. I recently purchased the kit to add a key lock to the outside. Well I unscrewed the screws holding the latch on the inside of the door and it dropped down into the door frame. I have tried magnets to pull it up, which didn't work. Now I just have a ... (cont.)

I have a WinCore 7700 series tilt window. The constant-force balance ribbon detached because the plastic ribbon connector/retainer broke. I need the balance shoe connector or the complete balance assembly

It has the brand Truth on it.

Is all window latches the same? I need some like these

This is the bottom roller assembly for a mirrored closet door. I'm been unable to find a match. Need 6

The rail is 1/2 inches wide and about 15 1/2 inches long and the bottom shoe is about 1 inch wide

Hi, Do you have these hinges? Thank you