Viewing all customer Discussions for:

Door & Window

I need 8 of these they are 22" in length

Looking to replace two Casement Operators w/ brackets.

Looking for a thumb lever / latch that will fit into the pictures mortise. The 82-240 latch will not fit into the mortise that I have. I need the latch that is similar to the one in the 82-030 handle.

I am needing to find a replacement for this. It is a 26'' window balance. The ones I previously ordered had the wrong size end. It was too large.

Hello I need rollers for a sgd 2000/2500 doors, I'm sending you a picture of the sticker, the slider is 1 inch and a half thick I just need the correct rollers please thanks, Steve.

Below is an image of my sliding glass door with a pet door installed. I'm hoping to get a new receiving channel or some other method of allowing the door to lock and be weatherproof. Right now there's a gap between the door and the pet door insert, which is much worse when the locking mechanism is r ... (cont.)

Hello,I'm looking for a replacement for the part pictured above. It is marked "Truth Hardware", "Entry Guard". Short arm has stamp 20810. The long arm is 10 1/2", and the short arm is 4 1/2". Would you have anything like it?Thanks!Brian

I need the replacement track for this 8' door with screen track? so three tracks. It's nearly impossible even though it's the simplest track I've ever seen. The rollers ride on top of the raised parts and that's it.

This is the pivot foot on each side of each window. It is 2" tall x .75" wide. Not sure if these are even made anymore. These are for tilt windows. I can get better measurements by removing the shoe if needed. These windows are circa 2000 and the brand name is unknown.

Can you tell me the make of this operator. I have 6 to replaceThanks Larry

Originally I also sent the pictures of the balancers that I also need (I am attaching them here again). As you can see is a 29" long balancer with the number 2830 stamped on it. This balancers are for Rollyson windows. If you could please let me know the part number I will really appreciate. If you ... (cont.)

I believe this is a Series 351 but I do not recognize the stamp. Can you determine if this is correct or if it is a custom balance?

I saw a you tube video showing a guide track cover being placed over the existing cover showing your part and being installed by simply using a piece of wood and a hammer to put the part in place. This is exactly what I am looking for but the only thing from the video said to contact Swisco but did ... (cont.)

One of the guide/retainers that holds the locking bar on my casement window is broken. As the locking bar moves up and down (lock/unlock) the missing guide does not hold it in place, Which results in the bottom of the window not being secure. Can you supply replacement retainers, preferably in met ... (cont.)

I NEED A SET OF DOOR HANDLES FOR REPLACEMENT TO THESE IF SO LET ME GET 2 SO I HAVE ONE FOR BACK UP

This is from a screen made by Lindsay Windows out of Mankato. They can not get them any more. The turnbuckle needs to sit off the screen 1/4" to hold the screen tight to the outside edge of the frame. Each screen needs 6 of these bad boys. I need like 500 of them. Also looking for framing and c ... (cont.)

i did not find any markings these pictures are all i have

Hello. I have two different type sash locks I want to replace.pictures are attached. Thanks!

I have a contemporary 1980's built home with many crank style windows. Many of the circular crank center pieces are broken and will not open or close the windows. What is the correct style and replacement for these cranks, please. I am attaching two photos. Do I need to purchase the whole replace ... (cont.)