Viewing all customer Discussions for:

Door & Window

Could you please advise on the correct replacement part for above window balencer. Its about 20 years old Thank you

Length is 25.75. Picture added is stamp. Quantity is 4.

Hello, We are looking for (1) window hinge. Please see the attached image reflecting the dimensions.

I am looking for a replacement for the pull handles on our sliding patio door. The screw holes are 5 1/8 inches from center of hole to center of hole. The screws are 2 1/4 inches long. The door itself is 1 3/4 inches wide. This one did lock but I don't necessarily need one with a lock. The top ... (cont.)

The pin that the handle fits on has sheared off in the handle, do I need another crank mechanism or is there a way to replace just the handle and pin?

Need both rollers

Hardware Identification.

Hey there, I am needling to replace channel balances and pivot lock shoes on my windows. Attached are com pictures. The length of the channel balance balance is 34 inches, and the stamping on it says (see pictures) "33HD BSI". The balance in the photo is very broken, but I think it will work for ide ... (cont.)

We need to figure out what to order in replacing the full triple balance complete set. The numbers on two of them read: 35" 232209 #4.0 35" One of them : #3.0 35" and number is not legible.

Can anyone help me identify this glazing bead. It is so brittle that I am having a hard time to get a piece that shows all sides.

Old window purchase from Castle windows and needing hardware to replace and install.

I need tilt latches left and right plus thumb button actuator length 4 1/2 inches not including part broke off width 1/2 inches height 5/16 screw hole spacing 2 15/16 actator length 1 1/4 inches total height 3/4 inches width 5/8 inches

Looking for a replacement plastic stabilizer for the locking bar

Hello, Am looking for1. sprial balance blue tip (photo attached) and2. Plastic anchor (circled red in second photo) where the screw goes inTotal window opening 59"×31. So, top and bottom sashes are 29"×29" each. Spring length in balance: 16". Tip to tip of balance: 29"Length of exposed ... (cont.)

This is at the bottom of the window and it helps it open and close

Hello, I need a clip or something similar to the photos attached. If possible. Thanks for your time. -Peter

Hello I am looking for 6 spiral balances and guides long with 20 handles and 2 tilt out release buttons. I'm having trouble figuring out exaactly what parts I need and was hoping you could give me a hand, I have included pictures with measurements. Thanks

need help identifying spiral balances I will need to get back to the property to get count but there are at least 7 windows of this style balance with a couple of bigger ones now that I know what I am looking for. Can you help with which style these are?

I think this may be a truth or true unit for an arm unit for a window.

i'm looking for this part goes on the bottom of the window sash it is 17" long