Viewing all customer Discussions for:

Door & Window

Does the 82-008 work on a 1.25" thick door. Original DNS 1400 12 inside has a track that holds the hook and it allows the hook to be moved inward or outward depending on the depth of the door to center it. Similar model lock set at Home Depot/Lowes like your 82-008 does not allow hook movement for ... (cont.)

looking for window cranking mechanism for anderson AW4 awning window. the number stamped on back of existing crank is 1521106. thx. it's for the bottom window.

Just want to make sure I am ordering the correct part. I'm 99% sure this a 29inch channel balance...part 2865. Just wanted confirmation if possible. Thanks

two and 1/16 center screw to screw. VIking in three dimensions. Paddle has LOCK on one side and OPEN on the other side. House built in 2004. Just moved in. Want to replace one lock. Do you think 90-278 would be the correct replacement unit?

Looking for replacement plastic or nylon track keeper for window locks for crank out windows. cant lock window down without them. the locking bar is 35 1/2 inches long. I believe they are called a winged tie bar guide ??? Thanks for help

I need to order 8 channel balance items. I have attached photos. number stamped on the front is 2320:

1-1/2" full view storm door with brushed nickel handle ,latch and keyed lock assembly

I need to get two of these parts please

Will this lock 82-399 work on a Pella swing door?

We need two of these but we are not sure of the part number. Can you help?

Hello, I am looking for a storm door latch. I will attempt to send a couple of pictures. Notice it has a key lock on the outside and a small lever that locks the inside. The reason I need one is the key lock must be broken because it falls out.

blue bearing plastic tube 27"

23 " as measured on the metal. Thanks

Trying to find part that fits here. Thanks!

The center to center distance of the holes in the tilt latch is 1 3/8".

I need at least 4 of these plastic or nylon glides/ guides for my vertical single hung sliding windows. They help keep the window from moving back and forth or side to side and keep the window tight to the track and in place. See attached photos for part I need. Thanks!

I have a Sash Controls model 2260 that has key entry on the outside but I am missing the key. I removed the two screws on the inside and removed both inside and outside handle pieces with the intention of going to a locksmith. But I noticed the holes in the door where the screws came out, now is cov ... (cont.)

Need 12 of these

Hi. I need replacement window balances based on the images. The balance is 22 inches long and the width is 1/2 inch. I also have also attached a photo with the only serial number I can find.. Any help would be greatly appreciated. Thanks.

I think I need to replace this mechanism. It is a Wright/Hurd 07701-00 Single Arm Operator Window with the length of the arm (from the bend) being 12". It does not operate properly. When trying to open it would skip and when looking at the removed part it seems like there is excessive up/down motion ... (cont.)