Viewing all customer Discussions for:

Door & Window

order some and it was only 5/8 in the window overlay it would not snap in to hold the window - the glazing out of my window is 3/4 inches (as shown in photo) when replacing the glazing should I do all four sides?

I am not a professional window person. I've heard the piece referred to as a sash stop, sash cam, balance stop... It is from an aluminum window, top of the lower sash. I have found replacement balances but have been unable to locate this part. Got any suggestions?

Please see the attached photos. I'm looking for the Truth 24-45054 light beige round opening with tightening screw. Your part 39-114L Truth 21-45240 spline is too shallow and has wings. Thank you for your help! Dan Stack

Please identify this part for me.

Looking for part number for Tilt clips for Series 78 SH Tilt

I cannot identify the mfg of this door, as it is nowhere to be found. I suspect that I will have to use a part that was not made specifically for this door. While I did not measure the door thickness, it is between 1 1/4" and 1 1/2" I think, as I did measure the hole on the end, at is 7/8" in diam ... (cont.)

I need about 20 of these. Do you have these in stock and how much plus shipping. Do you ship to Ontario

Cant find brand of this window. Looking for operator. Thanks !

Looking for part identification and place to purchase the parts for Alside double hung tilt windows.

I have several windows that I brought these out of I can't seem to find them on your website hopefully maybe you can help me out they measured out 34 in but it says 33 on the imprint of the rod so I'm not sure if that's just a part number or a length

These older handles are getting very loose and I was wondering if they make any replacements for them or if we have to replace the whole crank system. the plastic bushings where the cranks go in have worn some but the metals on the crank and unit are ok. You can still wind them open and shut but the ... (cont.)

Trying to determine if you carry the replacement parts for these channel balances. Our windows are non-tilt & the balances are 1/2" Thank you for any assistance! Margaret

BJ14 5#19 8-87, 11600-17 Looking for R & L Not sure what cross reference # is, any help would be great

Hello I am trying to identify a balancer window built in about 1970. The # 2040 is stamped on a balancer I removed from one room. Not sure if that is original or not. The length is 21"inch. I believe it is 1/2 inch width. Thank-You serge

Need to replace handles

39 inches long 1/2 inches wide Channel Balance Markings DB L03 and 3950

We purchased about 20 replacement vinyl windows from Gorell Enterprises in 1995. A few years ago the balances began failing. We currently need to replace at least five of them. I've attached a photo of a lower sash, hoping that you can identify the style for replacement. Please advise.Thanks.Dan ... (cont.)

The distance between the outside holes where it attaches is 7 1/4 ". I don't have the handle

Hi I need all parts in picture for an Anderson sliding door

Pictures of the Top Sash Guide are attached. the channel is a 5/8. the height of the entire clip is 1 7/8 tall, 5/8 wide, 1/4 inch to the top hole for the screw, 5/8 from the tab to the bottom of the top plate, top plate is 5/8 x 1/2. What is your closest suggestion? mine has a "groove" running ... (cont.)