Viewing all customer Discussions for:

Door & Window

Looks like the right measurements (close at least) but on mine the boots slide in a channel on the sash rather than a rod. Can this replace and does the kit contain all hardware to convert?

To Swisco, I have to replace many spiral balances. However, they are old and not color coded as the new ones are. I am hoping you will be able to help me identify and supply the balances I need. The metal cylinder is 27 in long and ½ inch wide. I have also attached a photo of the end part. Thanks ... (cont.)

What is equivalent part?

Replacing a 11x14" glass window pane in a metal frame. Old glazing is brittle and broken. I am looking for a direct replacement to snap in for the new glass.

Do you guys have this kind of roller for an aluminum door?

I was hoping somebody could help me, I have a sash window balance that is stamped 25 9. The channel measures 25 1/2 inches Thanks./kk

Summerville Aluminum in NJ custom made a storm window frame and window which fits over old single pane picture window on my home; the window pane is secured with small plastic holders which slide into the grove where the window sits thereby holding it securely; the last holder broke and the painter ... (cont.)

Here is a picture of my window. I have 4 in my home that don't close completely. One corner of window is loose. The other three corners, when I press against them seem tight against the frame. A lot of cold came in this winter. It was my first winter in house. Any ideas would be appreciated. ... (cont.)

I'm trying to determine what rollers to purchase before sliding glass door is removed (long story). It's too heavy for me to remove. It has PPG Herculite K glass, standard 8'x8' opening, home built 2003. Pictures attached are from the SCREEN Sliding Door, my attempt at gathering as much info as poss ... (cont.)

Looking for a replacement handle cole sewell

The balance springs are stamped with the number 2920. I also need the plastic end pieces as shown in the picture.

Hello, HELP! Can't find in any local HD, OSH or ACE Hardware. Can you identify and advise if you carry this please? I need 2 maybe 3 replacements please.

I see the original door sweep for: (SWRI 98038-05-01) (28915) has been discontinued. The bottom of the door is 31-1/2/inches long x 1-3/4/inches thick. As you will see in the attached photo's, the door sweep is set inside the bottom of the door. Could I use 58-189 as a replacement - "36" high pe ... (cont.)

This is a Milgard non tilt window that has a 27" balancer (26-5). There is a plastic piece that connects to the window that is broken and in photo. This part of the window is the window that slides up and down to open and close. A number printed on the bottom on the window is 1116772.004. Hope this ... (cont.)

my Insulwal window won't open. It is hung up at the lock, even with the lock disengaged.what is holding it up?? The top moves slightly, and the window is free to move up and down, but won't release at the lock.

Caradco. Low-E2. IGCC CBA. IGMAC CIC-3 2-03

The pictures are of the right hand side of a casement window pair. The problem is on the left hand side, the straight bar that connects the sash bottom to the bottom window frame has rusted at the sash tip and broken the pin that it pivots on at the bottom of the sash. In the "CU" picture the RH bar ... (cont.)

Hi I need some help my windows will not stay open I attached a photo of the parts I may also need the balance rod as mine is a spring can you tell what parts I need Thank you Ton

Do you have this? Thanks Rob

Window that I'm trying to fix. With your help I will fix it need these parts.