Viewing all customer Discussions for:

Door & Window

Good morning. My name is Greg and I reside in NJ. I also have a second home in PA in the Pocono Mountains. In that home I have a room with several casement style windows without any markings. The room has a sliding glass door with matching framework and indicates it is an Andersen glass door. The ca ... (cont.)

Trying to identify my balance. It has the following numbers on it; 1600-17 S1 21027 2-88 11600-3

I just purchased a home built in 2001. I have 2 sets of sliding glass doors, 3 panels each. I may or may not need rollers at this point, but I do need 4 new latch/lock assemblies. I tried to buy some from Lowes, and although they

I need to replace several 30 inch window balances. 5/8" wide, 5/8 " deep. Plastic ends are broken per photos. I believe your 30" series 385 channel balance, prod code S385-30 will work for me. Am I correct? Do you need overall window measurements? Thanks so much for your help. Loleita ... (cont.)

This piece is 2 5/8" long by 11/16 wide used to hold dbl hung window in track

2 1/4 x 3/4 x 3/8 inches House was built in 2004

Here is a picture of my lock from my sliding glass door. I cant seem to find it anywhere online. There are no numbers one the peice. Also i believe it to be an older door the pointed end slides into the door itself and the lock engages n. If you can help me that would be greatly appreciatedre ... (cont.)

I have Jordan windows similar to those shown on your u-tube video, except my windows do not have any take out clips. What is the procedure when there are no take out clips?

Looking to replace window locks in my kids home. They have single hung aluminum windows & the house was constructed in Little Rock, AR in late 80's. The measurements appear to match those for your 90-005 displayed on your web site. I am attaching photos for you to review and confirm or advise otherw ... (cont.)

I need replace this part of my window but don't know the model

I

Greetings, I am having trouble removing the tandem rollers on a vinyl patio door installed in a new home in 2000 outside of St. Louis MO. It resembles your part #81-157. When I remove the top mounting screw on the side of the door, the rollers do not come out on either side of the door. It ... (cont.)

Am looking for replacement T-Seals for vinyl windows. It would appear that your 187 T-Slot Offset Hollow Foam Seal,12ft is correct. Please confirm

Need several old PGT balancers. No numbers on these. The 'spring channel' is 34 7/8 inches & the 'tab' on the end is 1/2". Thanks! Bob

My 2 window channel balances broke. I attached a few pictures of what it looks like. The length is 29 inches and the track is

Hi, I'm looking for a replacement lock set for An Andersen Sliding Door PS11 6R Oper. It is a 2 panel door and was installed in 10/82. Can you help?

I have two 2640 Sash balances that are needing replacement. My top part looks like the 19-005 while the bottom looks like a 15-002. What series unit would i use to replace the balances. Thanks Chris

Thank you for any help you can provide.

I purchased 2 parts from Swisco several years ago. Part # 38-013 and 38-014. Right and left window locks. I neglected to purchase the part that secures into these. The other half of the lock system. These parts are no longer on your website. Do you have the coordinating piece that would fit the ... (cont.)

Hi I'm needing two sets of the awning sash lock arms and one crank arm cover plate, pictured. Let me know if you can help, Thanks, Winston