Viewing all customer Discussions for:

Door & Window

I have a large picture window that has a storm window. The storm window fits into a track on the outside molding. On the top the window slides up into a clip that runs the horizontal length of the molding. But there aren't any clips or fasteners on the sides or bottom to hold the window in. In t ... (cont.)

Need to replace two window balances due to broken cord. The markings are "27 4 BN CALDWELL" and the metal section is 28" long. Pictures of the tops and bottom posts are attached. Thank you.

The crank handle im looking for is as the added picture shows, the measurements are 5-1/2L X 5/16W. I have found many with 1/4 width which is too small for my window. If you could help me find some of these I would be very appreciative. Thank you

Hi there! Do you know where I can find coils for this? I haven't been able to find them anywhere. Both have snapped in my window. My shoe is nearly identical aside from a hole for where the window goes in. Thanks for your help!

I also need help with two windows Channel Balances. The stamp on the first one is 2730F, the 2nd one is 2140F. The attached shoes are the some. Please help me to find the series #s. Both of the Channel Balances are 1/2" wide. Thanks a lot!

I can't get this plastic glazing out so I can replace. Please advise. Thanks, Garry

I placed an order. My part says 2630X But could not find the 2630x so I ordered 2630. Will these work? Please advise. Thank you. Dave

Hello. I just spoke with someone at Plygem Windows in Rocky Mount, VA (closest location to my home) and they referred me to you. I have three MW windows in my living room and two of the windows won't stay up when I open them. Upon closer inspection, the two windows in question have one broken spi ... (cont.)

Here are a couple photos of my latch.

I'm looking for this top sash guide for a non tilt window. I tried to put some measurements on the pictures.

Looking for a replacement double hung window lock. The one I have is a Sunair Aluminum Corporation. Dimensions are as follows:Length between bolts 2 3/8 inches, width 1 inch.

This may be a stupid question, however is the color of your foam core spline black? Can't quite tell from the pictures. Thanks!

My embossed numbers are BL23 10#31 10-85. What is the new # do I need to order? Thanks for your help in advance. Ron

Do you have window rollers for Sunaire Aluminum windows?

I need to find a replacement roller for my sliding patio door! I can't seem to find one that looks exactly like it in your catalog however I'm sure that one should fit? It is an Allen Stevens part no 68 30 Please see attached photo for reference! Thanks in advance, Peter

To whom it may concern, I need some replacement Rollyson (circa 1986) top sash guides, and the ones you have pictures in your catalog are almost identical to what it on my window. The only thing that appears to differ is the 1 7/16" dimension depicted in your side view. Mine is only 1". See attac ... (cont.)

On the site I was looking for a #407 Spring replacement for a certainteed window. The broken one I have has the number 407 stamped on the end. On you site, the 407 spring comes up with two versions (S170-407 & S171-407), same number, virtually same description, but different part numbers. Could y ... (cont.)

I have to replace a broken pivot shoe part #15-047 black cam in the lower sash of a heavy triple glass aluminum window. I tried to print out the installation instructions on your website but cannot seem to do it. Could you please email me the instructions. In addition the spiral balance that was the ... (cont.)

malta thermacladll double hung windows 5/16" thick 3/4" long

See attached images. The marking is 20 4 B0 CALDWELL