Viewing all customer Discussions for:

Other

Replacement pin for window pin

Nami code: fet series bgd/?from/???/bfs narcissism fet-1-003

I added two photos one of the opener and the other showing the hole locations on the window. The numbers I sent in my previous email is from the old handle. When I bought new handles the holes didn't align and that's why I need the exact model number as I have now.

The attached photos show a damaged balancer for my single hung non-tilting window. The balancer metal length is 34 inches, the cross section is approximately 9/16 x 5/8. The window size is a 4'5"x6'0" window manufactured by Flesher Windows, which is now part of Eastern Architectural Systems. The ... (cont.)

We have a wooden door that has a jalousie window. The crank to open the windows no longer works. There is no part number on the current device. The length of the crank handle that needs replacement is 3 3/4". Thank you in advance for your assistance. Lynda-Lee

I have a white Cole Sewell storm door installed in the early '90s. The door is still very functional and cosmetically good. The handle is no longer functional. I have taken it apart; the cam that controls the position of the latch is completely worn and useless. I would like to replace the the entir ... (cont.)

Looking for a carefree pivot bar the window was manufactured in approximately 1997 or 98. Measurements are, from the shoe end, is three quarters of an inch to the first hole, first hole to second hole is 1 in, and total length is 2 and 1/4 in.

Operator does not work, is this the only piece I need to replace?Left Lock

Hi, I need to replace 7 Andersen sash balances. Old balance #s D5 7 27 12 70 Purchased one new balance #737, is this the correct balance to replace the old balances with? Thx, Scott

Hi, My uncle has a couple of kitchen drawers on the sliding tracks and the anchor track piece is broken. Can you help with a replacement recommendation? I found these on your website (HANGING RAIL BRACKET, 1-7/16" DEEP) but not sure if those would be the correct replacement. I have attached a couple ... (cont.)

I need four of these top guides. Since they are plastic, I could cut them down or re-drill the mounting hole if necessary.Albert

I need replacement drawer bearings or slides. They are approximately 3/4 be 1/2 inches by about 1/8 or 3/16 of an inch thick

The label on the window says mastic windows 2222/2230/2232 hung pl# 466-003. It seems that the top part of the lower pane is disconnected from the window sill and that pane keeps falling over, and it seems to be because of broken tilt latches.

The mechanism is not working properly, I can open the window, but when closing, it gets blocked.I hope you can help me, it looks I need a new mechanism. Thanks, Constantin

Can you help me identify this part?

I am not sure what the numbers on the spring mean? I need to buy a few of those springs for my window repair. Just like to be sure. Can you please let me know? Thanks Jack

Window

I purchased your parts #26-243 and 26-244 but they are slightly too large. Do you have anything else that might work? These are 20 year old windows, builder grade. I have no idea who made them. Thank you for any help

I recently purchased a home with KK windows, but for some reason they do not havve screens on them. It appears that the window is set up to receive manufactured screen but these windows do not have any. Is there a place in the USA that I can buy these screens?

I have a Silverline sliding patio door. Does the 82-086 fit this door?