Viewing all customer Discussions for:

Other

No lock and only entry to apartment downstairs. Need to be able to lock for tenants. I was told it's an aluminum slider from the 80s I need help! What can I buy so they can lock this unit?

I think I need the S795-30, but I want to be sure I don't need any other parts of accs. to make this work for my system. Let me know what you think. Measured at 30"

Hi Looking for 4 pcs of sliding balance from Pellla. Attached pictures Length 23,3/4 Metal to metal 25 inches tip of plastic to plastic 9/16 thick. Stamp number shows #2340 I need advise please Thanks Andre

Hi - I have some sliding doors where the wheels do not very well. Wondering if you can identify the type of wheels we need. Thanks for your time!

Unfortunately the door got stuck in the lock position and I had to cut the lock and lock cylinder.I only need the actual mortise locking mechanism and brass lock cylinder. I have all the other brass components in usable condition.Also I'm looking for the rubber sweep which I sent a picture of on t ... (cont.)

Need top and bottom double hung

There is a marking of 730 DG Overall length is 29 inch includes both end of plastic part

There are no markings at all. Arm is 5 1/4 with wheel at end. And hole pattern is 3 inches apart. ** This is for a Garden window by the sink and has a window that vents open at the top of the window with the crank handle and arm to open and close the window.

Needed a replacement lock for my door. I also am not sure of the model number or manufacture of door. It is a 107X80 brown aluminum door. I was also looking for the rollers!

I need to order additionally the plastic clips which screw into top of window to catch top of balance . I have attached photos of it. Can you please help? Thanks!

I am looking for a replacement mortise lock. there is no manufacturer name listed on it. The second picture shows the numbers on the part I want to replace. This lock had rods that attach that pin the top and bottom as well. I do not need the rods.

Distance from center of hole to center of hole on locking mechanism is 2 and 1/16 inches. Underside of locking mechanism as shown in picture has "2 R". Latch receiver distance from center of hole to center of hole is 1 inch. Trying to replace these part, as some are broken or missing. ... (cont.)

I need both right and left internal latches. I have included measurements to provide as much information as i can, unfortunately i do not know the type of windows that i have. Thank you for your assistance...Judy M.

Unfortunately both springs came loose from window. There is a part number on the channel section, 2430Y

I'm attempting to reinsert this metal spline in a metal storm window. It's Very difficult and not cooperating at all. Do you have a vinyl or butyl replacement? Looking at it from the side, it's overall 1/2"

I have this sliding glass door. I believe it's a Silver line . The handle locks on the inside of house only. I need to be able to lock the door from the outside when I leave. Can you help me with thisI believe it is a 3 15/16th center handle. This is a for a 5ft sliding glass door. I need to be able ... (cont.)

I have a broken part from an aluminum commercial window. Non tilt. It fits in the track and sits below each end of the window. Is this called a shoe? The plactic part measures 1 3/16 across and 2 3/8 length.

looking for plastic ornate molding on drawer face

Looking for matching vinyl glazing bead.

Need 2 replacement balancers for bottom sash. Pics are of top sash balancer. I don't have the bottom balancers so can't send pics of those - should they be same as the uppers? Bottom sash is same size as upper. I need supplies for full replacement: balancers , guides, clips, rivets, rivet set tool, ... (cont.)