Viewing all customer Discussions for:

Other

We have multiple windows that cannot open bc the crank is stripped or completely broken like this one. The metal gear plate says truth What pieces do I need to repair these? The rest of the window(arm lever) is fine Thank you I am good with following directions to fix things

Hi. are there enough photos here to identify which balancer this may be? I'm afraid If I take the window out for a closer look I may not be able to get it back together. and the new part may not be available Thanks

Good afternoon, I am trying to replace both a keyed deadbolt lock and door handle on our sunroom door. They have separate "bolt & turn" mechanisms that are held in place by two screws each. The exterior trim (key hole and handle) is separated into two pieces. The interior however is all one piece ( ... (cont.)

I think it is broken, Let me know if that is correct. Numbers are 26B RH BSI, Need to know what is the replacement item.

The plastic on two coil balances have deteriorated due to sunlight. I can't find any markings on the balances. The single tilt sash weights 20lbs. I'm looking for all new coil balance and shoes. A picture of the window sticker and the balance on another similar window. Do I buy two 10lbs coils? ... (cont.)

Hello;The rear bracket for my Merillat pull out drawer has broken. Do you carry a bracket that is compatible to the Merillat bracket?Thank you,Vicki

Hello! Thanks for your help. My door will only accommodate a quarter inch mortise (I think that's what it's called?) but the only replacement parts I can find are for 5/8th. Do you have anything that might work for me? Thanks again!

The Simonton parts looks to be the closest. Wondering if the markings help recommend a replacement.

Hi, Can you please see if you can match this part (slide bolt) to storm window ? Thanks,

Hello, I have two Oldcastle shower enclosures. I need to replace the molding that sits between the glass and the C channel on the inside and outside. Is this a part you carry? Thank you,Nicole

Do you have this type of Vinyl, can you identify what it is? If you have it i can give you the amount needed later. please let me know.Thanks,David

I have finally got all the weights and sizes for the double hung windows that I need parts for. Here goes.*Total size is 40 widthx54 length inches weight is 12.8# The sheath with spring inside with attachments is 29 inches. Need 8 sheaths and springs. Pictures of the attaching parts are in ... (cont.)

Have been discussing replacement channel balances with customer service. This is a 27" balance with a 2690 stamp on it. Bottom shoe measurement is 7/8", so customer service stated this will need to be custom. I am looking for (4) balances. We have identified the top sash guide as 18-161. ... (cont.)

Channel balance

Hello I'm looking to replace (6) of the attached . I am unable to identify by a number but I noticed the word Truth on something . Please advise Regards

I hope you can help. I need to replace the weather stripping on the bottom of the frame that meets the sill. The stripping on the window in question has completely crumbled out. However, the ends are closed. Do you have any suggestions for how to install the weather stripping? Thanks. Tim ... (cont.)

I am looking to replace the track and rollers for my closet doors. I have added the pictures for both parts. I am looking for something that rolls easier. If possible, it would be great to add a soft close to the top guide. The door panels are big and very heavy.

I need help identifying the right channel balance to order. The closest I found was S370. The bottom shoe looks like an exact match, but the top doesn't quite match because it has wings. Here are some pictures attached below. Total length is 25", channel is 1/2" and tension/weight is 2430. (Not ... (cont.)

Can you tell me what I need to buy a replacement?

The numbers stamped on the balancer are 20D BSI FN. is the entire balancer replace-able or is there are parts rebuild kit!Bill