Viewing all customer Discussions for:

Other

Channel length is 26.5. I believe it is Milgrad and it was made around 2006. I will need 4 of these.

Hello, I'm looking to replace both my balance's, not sure if it's a model 380 or 385. The metal housing is 20 inches. I have enclosed pictures of the stamp and end pieces. Thanks for the help!Nate

The item that is circled is the part I am trying to identify. TRUTH is the manufacturer but I am unable to locate the correct hole pattern. I believe it is the "Maxim operators" series. Any help help is greatly appreciated. Best Regards Mike

The flip lock on the handle is broken. Looking for new handles with inside flip and outside key lock. I believe this is a peachtree door and mechanism.

Could not find anything matching in your parts pictures. Do you have anything that could be made to work . There are no names or numbers on the roller assembly or the door. The wheel is 1 1/2" metal. The assembly is 2 1/4" long without the tab, 1 5/8" tall and 5/16" thick

Hi, I'm looking for a replacement parts. It's 26" long channel balance with 2640 part number stamped on the bar. Do you have replacement? Thanks

I need to replace a couple of window sash pivot bars. They are the one in the picture. I would like to verify the Window Sash Pivot Bar part number 26-360 is the same as the one in the picture and the screws part number 33-071 go with them.

One of our window cranks broke but we have had a hard time finding the right replacement. We would appreciate if you can find the right one for us to purchase!

Hi ... I need to identify this 35 year old Milgard balancer. The sticker on the window frame says Series 1500 , DH-R20, MST: 4060The only numbers on the balancer are 2603Eonline I have seen 2630ec, 2630ep and 2630ex. Could you please help me identify the correct part ?Thank you,Ray ... (cont.)

I need this replacement item; do you have it in stock?Email or call me Thank you,Mike

My right handed Pan Am Window crank looks like the 39-017. The top holes 1/2" apart and bottom holes 1 5/16" are the same as mine. The difference is between the top holes and bottom on the 39-017 are 5 1/4", mine are 5 1/8". The 2 3/8" arm on the 39-017 are 2 9/16" on mine and there are no threads. ... (cont.)

I want to buy part of window.Xuedong

looking for 1997 pella patio door multi-point handle kit with key lock

Drawer is completely loose and flops around when I try to use it. It seems at some point the part of the plastic piece that fits into the track at the bottom of the drawer hole snapped off. The plastic piece is attached to the metal, so it would seem I have to replace that whole half of the track on ... (cont.)

The metal pieces are approximately 1.25" in length x .25" in width and allows the window channels to be installed and removed. They hook into a small square opening at the sides of the vertical window frames.

Do you have a replacment for the picture above

No writing

No writing on it

I am needing to replace several of these types of Pivot Tilts in my house. What matches this picture that I can purchase? Thanks, Darrell

good morning! I have 2 different size SWISCO windows that do not stay up. They are non-tilting. Is this because they need new balances?Thanks to your you tube, I was able to remove the windo and remove the balances to get pictures. Attached are pictures from my 25" window. I will send separate photo ... (cont.)