Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

Hi, I believe I need 39–348 based on the attached photos and the width of 24 inches. Two of the screws lineup roughly 2 inches apart, but I can't see the other two screws because they may be hidden by the arms. Can you confirm that they are about 4 1/4 inches apart? It also appears that I need ... (cont.)

Hello, Please help to match a part number for Truth Entry Gard, I measured the short arm ( 2 7/8 Inch ).

I am looking to replace the window crank in my Hurd window cthat was installed roughly in 1998. I believe it is part no 39-090 but am j sure. I do the measurements and it is the 5 inch variety. Can you also confirm the replacement handle and any associated screws and clips. Thanks ... (cont.)

Truth with # L30841 on long arm and 20810 on the small arm overall length of arm is roughly 9 inches.

Looking to replace the crank and linkage. Can you identify these parts?

It is stamped truth hardware, from mid 1990's, trying to to find a replacement, casement window, approximately 30"x60" tall. thank you

Bow window.

These are pictures of a part that is identical to another one of mine that has the crank handle broken off.

I need to replace a handle from the crank mechanism on my Marvin windows. The number on the back of the handle is 45054. They are Marvin windows from 1991. do you carry apart which would fit this?

I'm trying to identify and locate replacement window cranks for Jeld-Wen casement windows.I'm needing LH & RH cranks & opener arms for casements that are approximate 25"X54".I'm also needing LH & RH cranks & opener arms for casements that are approximate 17.25"X32".Please see attache ... (cont.)

Hi, I'm looking for a replacement part for two casement operators. Attached are pictures of the operators for the right window, and there is a mirror version for the left window.If you could tell me the right replacement part number that would be incredibly usefull! thanks Florent ... (cont.)

The house was built in 1990, and the window crank for this Peachtree window is broken and needs to be replaced. I’m looking to figure out which parts I will need. Thank you.

Based on the photos, can you help me verify that the following part numbers: 39-032, 39-107, 39-114L are what is described in the photos? The existing crank has the following numbers: R30842,40471, 20810

Our client would like their basement window repaired. Please see the attache photos, the broken piece has "45054" printed on the underside.

Trying to get the handle so I can replace the broken one

On the ARM- GU then two arrows on the back of the body- US PAT 6247,270 CA PAT 2,278,430 operator is beige tan colors

Crank can open window but doesn't close window. Wondering whether any of your awning cranks would work.

Missing the crank handle and cover on one side. Also missing one of the latches

The crank handle of an awning window has come out and cannot seem to stay. The crews may be stripped. The window is original to my house which was built around 1991. We plan to replace all of the windows but I would like to limp along a bit more with this one. The only numbers or lettering I fou ... (cont.)

House was 4 yrs old when we bought thus 1988 built. The Sill is wood but might have thin plastic cap full width however I can not remove screws that hold the handle mechinizum under sill, 4 -6 screws. Thinking about removing ~ 1/4 inch thick piece of sill above mechinizum so as to access srew heads, ... (cont.)