Viewing all customer Discussions for:

15-105 Pivot Shoe, 17/32" Thick

In need of this pivot bars and pivot shoes

Looking to replace the lifts in this Kinco tilt window. There is a stamping of 2450 on it. It's 25 inches long.There is one on your site that looks like it but mine has a hook it the bottom.

I have 20 dbl hung aluminum windows that are no longer operable and requiring the old balancers to be replaced Units are about 30 + years old and all tilt in, was able to remove the balancers but couldn't extract the pivot shoes Is there a specific formula on removing and installing these? ... (cont.)

Hello thanks for your help I'm looking for this balancer plus the pivot tilt piece do you have a few options that might fit for this old aluminum window in a building I need about 100 of these?

The spring came loose and the pulley string clip detached from the track mechanism so the window doesn't open evenly nor stay up.

I need the corner pivot pins/bars and sliders with the springs inside. I think the bottom is broken. The bottom of the channel bar with the hook is missing the attachment that the cam pin goes into. If you want to call me. What about the 20 channel bars? Here is a picture. I need 6 of the channel ... (cont.)

I recently purchased 26-416 for a Harvey window. Apparently, I broke the originals when I tilted the window when it was all the way at the bottom of the track. I replaced the pivot bars and then installed them with the window up about 8? ? however, they twisted again (and almost broke) when I reposi ... (cont.)

Hello, Can you please take a look at this channel and tell me what I need from your store to replace them? I'm assuming I need new accessories and not just channels? Thanks very much and I hope you have a great day!It is 31" long. Dan

Hello, I am looking for the pivots and the clips for an older Harvey double hung window. I have attached pictures of the old parts. Anyway you would have a replacement part?

Good Morning, I am looking for a pivot shoe and the clips to go with it for and older Harvey double hung window. I've attached a picture of both parts. Thank You

We need a pair of these (for starters) 28 inches long with a depth of 1/2 inch to hold up a 16 pound window. Uses a hook style fastener as shown in the photo. Any guidance you can provide would be appreciated.

Looking to find a new balance, and I'm not sure of the type that matches mine. My original does not have any pieces on either end as you can see.

The balance is 18 inch long and the pivot are in the picture

Please identify the correct replacement channel balance for my Pennco window. Only the bottom window moves up and down and tilts out for cleaning and removal. The top window is stationary. I have submitted five pictures to help identify the correct balance. The channel balance is 34 inches long and ... (cont.)

The balances are marked with 2340 and 2840. They have no nylon tops or bottoms. these are tilt windows. I also need the pivot bars and guide shoes/blocks.

29 x 9/16 x 5/8 2830 JL stamped on side BSI Sash weight ~24 lbs

its the locking piece on the side for double hung tilt window. it hold the arm in place

I'm looking for these parts for my vinyl windows. Lucinda

The length of the balance is 32 inches, I need an order for 250 windows and I'm located in New York. The weight of the window I don't know yet.

Need to I'd this rod, 29" channel no plastic on either end 9/16 x 5/8 channel. Also any help with the shoe would be great.