Viewing all customer Discussions for:

15-178 Pivot Lock Shoe, Brown Brake Pad

1. double-wheel pulley (4813, 4812, 4800) that attaches to the spring (4803). Spring is fine 2. square bar (4813 and 4812)on bottom of the window that keeps bottom of window in the track and rotates the window-lift lock. broken at the hole where the screw holds in place. 3. window-lift lock (1/2 c ... (cont.)

Hi, I am looking for the window parts in the pictures below. I need 8 window pivot shoes, they are 2 1/8 " long and 1" wide and 5/8" deep. I also need 8 3/8" 28" long spiral window balances with the red bushing. Do you carry these in stock? I would like to drive there and just pick them up. Pa ... (cont.)

243877.002 double hung vinyl window balance shoe replacement. Do you sell and ship these?

Please identify sash hardware

These Quaker double hung windows were put in in 2000. This part is where the bottom sash hooks into so you can RIP sash out to wash the outside from the inside of the house.

Thanks for your help with my problem.The pivot bar #26-129 (third picture) is correct. The pivot shoe #15-152 (first picture on right) is incorrect, the one on the left is the one I am trying to replace. Size is good except 17/32 thick would be best. The second picture is the old one, note the recei ... (cont.)

The part on the right is the original and image on left works fine. With the newer part I have to replace a part on the window that fits in the shoe. Would like to order 26, however not sure which part to order from your website. I would like to order parts from you if I can get the correct parts. ... (cont.)

What part do I need to order? The one on the right side of the window is broken. 3 pics of left side. 1 of right. Thanks in advance!

Hi, looking for balance and boots for Integra series 201 vinyl replacement windows. Balance is 16" sash is about 15 lbs.Will need 4 of each. Also bulb seal for a bottom sash. Appreciate any help.

I have been trying to locate this part I haveattach photos please let me know if you can help or need more info thanks 3 Attachments

I am in need of many replacement parts for some double hung windows. Please review the photos

There are no markings on this window. I have several of these shoes that have broken and need to replace.

What will work for a replacement for this window. Plastic block is 1 1/4 x 2 1/16 x 17/32. It has a brake system.

1 1/2 x 2 1/2 was looking into the 15-188 would like to know which shoe could work as a replacement

I have a tilt window and needed a few replacement parts. I

I'm looking to replace the entire balance, pivot bars and pivot shoes on two windows in my home. The window jamb does not have cut outs to easily remove the pivot shoes but I'm concerned the vinyl/plastic components to the jamb will snap if I attempt to use the jamb spreaders. Do you have any sugges ... (cont.)

Window issues

Greetings. We ordered several Series 600 Spiral Tilt Window Balance parts for defective windows. We found out that the windows need new "carriers for the springs to anchor into," according to our contractor. Can you please help me find the carriers he needs? Scott

replacing the balances in shoes on my tilt in vinyl windows. My local supplier ran out of the shoes and the ones on your web site are slightly different. Could you recommend replacement part for shoe pictured attached? Also, I have a different peg on the upper sash, it has a round washer type that ... (cont.)

The shoe is approx 2 in by 5/8 In by 1 1/8. The spiral spring is 28 inches long and the diameter of it was around 7/16. These windows are vinyl from 2001. Can't figure out manufacturer. Looking for replacement parts and prices.