Viewing all customer Discussions for:

82-002 Sliding Door Handle Set, 6-5/8"

The CD347 sliding door latch broken. Can 82-002 be the replacement? Can the latch be installed on either side? Thanks.

I need 4 replacement handle/locks

The lock is broken & as best as I can figure it is the main sliding plate, that is attached to the J hook that needs to be replaced. The assembly is from a DNS 16 sliding patio door lock. NOs. 13/25 is on the outside casting. If that part is N/A then a complete lock assembly will have to do, as ... (cont.)

I was looking for a Marvin Screen Stop and sill strike. Part # 05700030 or 05700029. The handle is a Ultimate Screen Handle or a Marvin sliding screen door. The handle is okay, I just need the locking latch.

I have a sliding patio door with this stamped on the door: "acorn series 1200 cgsb 82-GP-2A" The current handle does not even have the capacity to latch, never mind lock, and so, I would like to replace it with a door latch that actually latches and at least, secures the damn thing from the ins ... (cont.)

Holes: 6 5/8" center to center Door: 1 3/32" thick Mortise: 13/16" x 7 1/8" Bottom of Mortise to the center of latch slot: 2" I need a handle set with a full pull on both sides, not just a little ridge for your fingers.

I'm trying to replace this sliding door handle. Original door made by Kinco and the handle made in Taiwan #NW 1720; installed in 2001. I'm hoping you have a replacement that will work as I don't really want to replace the whole door which is othrwise OK. If you need additional photos, please advise. ... (cont.)

15/16" WIDE - 7 3/8" LONG - 6 1/2" SCREW HOLE CENTER

Good morning,I need help finding the correct replacement hardware for my double sliding glass doors. I see the 82-002K model, but need the other side to close up the opening. See attached photo for reference. You can contact me on my phone Thanks, Bryant

Please help locate this lock

Need two new recessed patio door handles and hopefully new wheels. This home is in Laughlin NV and was built in the 80?s

Similar to Product Code: 82-002 ; 82-002K Horizontal bar (in the center of the unit which engages lock) drops and does not stay in place. Is there any way to tighten / adjust tension so that when you push up the bar it stays in place?

The 82-002 lock set shows that it comes with a lock keeper. Is this the 1/2 inch wide keeper or the 3/4 inch wide one?

I need to replace a patio door inside pull. Stamped as DNS Industries 16 inside pull standard. Patio door locks and unlocks from inside only. Measurements match your 82-008. 7-3/8 X 15/16. Screw centers 6-5/8. But Your latch is facing down and my latch is facing up. Thanks Lydia

The internal lock hook on the door broke, I have been searching for days to find a replacement kit for this. Reaching out if you know this door or have a recommendation for a handle that may fit this?

Hello, I have the attached door handles that I would like to replace; these are two different types. I cannot find replacement parts. Would you have these parts available? See attached pictures. Let me know if you need additional information. Thanks Gus C

Please let me know which part # I need to order as replacement

Trying to find a replacement part for this handle. The screen door is on a set of Marvin sliding glass doors integrity brand from about 10 years ago.

Can the 88-002 wooden door handle be used with the 82-002 patio sliding door handle?

the holes are same measureemnt but unsure if it will work. Can you tell me if it will fit and work