Viewing all customer Discussions for:

90-058 Keeper Shim, 2-1/16"

The parts I'm in need of are the Nuprime Season-All Patent Nos. 3,449,862 D 209.812 -D 213.676 Latch and the Keeper which has no labeling. The keeper has two screws located 2-1/16" center to center. The tab on the keeper has sheared off.

I need to replace this part for my tilt windows. I can't release the top sash to tilt in because this piece is missing. 1 5/16" from end to end Bottom middle tab 4/16"

The latches shown in these two pictures do not catch. Maybe the windows have warped enough that the sweep is not long enough to catch. Do you have any ideas? The sliders are double sliders. I ordered the 90-180 and the 90-183 keeper, but they are exactly what I already have that doesn't work. You ... (cont.)

I ordered sets of locks and keepers because we had old locks and keepers that were sticky and wouldn't close correctly. I replaced all of the locks and keepers with this product and it worked great on all of the other windows! I'm having trouble with this lock and keeper not lining up. I've clean ... (cont.)

I have Patriot single hung windows used by Hovnanian builders in NJ. I have been using Swisco parts to repair them but one window has a problem I cant diagnose. The balances, shoes and lock latches seem good. When I close this sash from the the bottom I cannot lock the right latch which is out of al ... (cont.)

Hello, I'm trying to source a sash lock and keeper and may have actually purchased this from you several years ago. Dimensions of the keeper: 2 7/8" long X 1/4" wide X 1/2" high. Underside of the lock has the number 3226 stamped into the piece. I need two locks and two keepers. Please advise.George ... (cont.)

The windows are (I believe) window world 4000 series. See attached picture showing window tag. I tried to raise the window and the right side didn't slide well. when I tried to pivot window in the right side was loose and I noticed broken parts on the sill. Is this enough information to reco ... (cont.)

MW window latch is UV damaged and cracked. Mounts on an angle instead of flat. Would prefer a metal replacement with bulk pricing to replace all latches in my home.

Hello, I've looked all over the window, window hardware, window glass, etc but can't find any information on the manufacturer or part number. When we moved into the house a month ago I noticed the windows don't close all the way so the locking mechanism is not working properly. When I looked that ... (cont.)

I need one of these.

I need some shims for a set of Jeld Wen window 'wen-lock" stlye latches. I was referred to you from Jeld Wen. Please advise

Patriot windows approximately 20 years old.

I need to replace some of my window locks. The windows are slipping from the top, which causes an opening at the top of the window - allowing air to come in.

Basically the windows at this place have a bow in the bottom of frame causing the windows to not be able to lock. All I'm trying to find is a lock and keeper system that the keeper is about 3/4 tall. Don't really care if it matches style can even be sweep locks for wood windows as well, just as long ... (cont.)

Hi. I was hoping you could help find a solution to a problem my home inspection clients are having. 5 of the replacement windows installed on their house will not lock. The lock misses the keeper by 3/8 of an inch because the upper and lower sashes do not line up completely. I understand that th ... (cont.)

Just purchased a house built in 1997 with Alenco AL windows. There is a problem locking every window in the house. They all close but need to go another 1/8" or sometimes less for the lock blade to fit into the locking groove. You can force them shut, putting enormous pressure on the upper frame ... (cont.)

I have 31 wide x 72 high double hung windows with a single sash lock similar to your 90-278. The single lock is worn and not strong enough to hold the top sash all the way up, resulting in a gap at the top allowing air to seep through. I would like to put two sash locks on each window to provid ... (cont.)

Hello - I just moved into a home with 8 "Weather Tamer Coastal Windows" - each has two 'Heavy-Duty Cam Sweep Locks'....however only one of the windows will lock properly. Magically last night, the bathroom window was able to lock(?). It seems that some adjustment needs to be made....either to the lo ... (cont.)

I am trying to replace a lock for a window, which I think is a Season-All window. The lock I removed says Season-All so I assume the window is also. There is a shim (see image called Window latch 1) inside a channel on the window (see image called Window latch 3). The latch is broken and I need to r ... (cont.)