Viewing all customer Discussions for:

S380-18 18" Series 380 Channel Balance

I need to replace four Chanel balances for my two non tilt windows. The only numbers I see on the Chanel balance is 17 2 JU CMC 2. The Chanel measurements are 1/2" wide by 18" long. I only measured the metal piece of the Chanel balance.

The metal channel part is 18 inches long. The marking reads, 17 4 KP Caldwell. This is for a Milguard window.

This is 18 inch with 1713 stamped

looks like the Caldwell 380 series. One length is 18", the other is 24". The channel is 1/2". The 18" Caldwell supports a 20Lb sash, so perhaps the #1750, and the 24" caldwell a 30lb sash, perhaps the #2360? The bottom foot on both sizes is 1". I also need a top sash guide that looks just like ... (cont.)

Hi,Need to purchase 6 x : 17 5 AT Caldwell2 x 24-14 LF5 CMC 54extra brackets that they hook into on window,see photo'sMuch obliged.Andre

I have these channel balance similar to similar to series 380 and 385 but not sure which one to pick. Looks to be 17 inches when measured and 1/2 in.label on back 17 3 DP caldwell

Hi, I would like to know what product matches the "17-5 CMC 2" window balance. Thanks! Best, Sarkis

17 4 BR CALDWELL is what is stamped on part.

I need to order 4 sets of channel balances for 4 windows. The channel balance is 18" by 1/2". Attached are the pictures. Let me know if you need anything else. Thanks, Bob

What part#'s are these 2 lengths?: 1. Stamp 17 3 HT CMC 4 Metal shaft: 18" x 1/2" 2. Stamp 28 4 KS CALDWELL Metal Shaft: 29" x 1/2" Thank you! Kalei

I need a replacement for the above

Hi! Just wanted to make sure I get the correct product before buying these for the whole house. "17 1" and "A 1" engraved on side. Unsure of weight rating. I was overly enthusiastic when removing the window and a plastic piece broke off but not sure if from this channel balance or the other one but ... (cont.)

Hi! I'm looking to replace a few Milgard Caldwell channel balancers. The stamp on the existing ones read: 17 9 26# LO Caldwell. What's the correct series balancer to purchase? Thanks! Ryan

Part number :b A1740

Need to order 2 channel balancers for one window the markings on them (17 4 DS CALDWELL) attached are 10 pictures measuring 18in each. Please let me know which ones I need to order. Thanks James

Measurement is tiny bit less than 18in.

Hi The # that they have is J 17-5 and the measurement is 18 inches long and 1/2 wire

Item needs winged top and bottom plastic piecesSteve

Dear Sir / Madam,I want to buy this Sash Balance for Single Hung Windows, but they must be complete with the correct Rod Ends installed on them.Inscription on the balance: B.S.I. 1710 FD and it's complete measurement is 18.9 Inches long.Please reply at your earliest convenience,Best Regards,Orlando ... (cont.)

Hello I need help determining the correct window balances for my window and ordering them. Let me know what other info you require to help me. Thank you.