Viewing all customer Discussions for:

S380-28 28" Series 380 Channel Balance

I had taken out the broken balance. The above part number is stamped on it. Please advise which pair to order from you. I had ordered before from you, with excellent service. Best wishes, Karol

Need two of these replacement window Chanel's please.

Looking for one replacement channel balancer

All the windows in my house are Hallmark brand. Need the part that supports the window when opened. The plastic end pieces are broken. Mental rid is about 38 inches. Any assistance is appreciated.The number on rod is 27 4 Bsl. The letters couldnt be seem with the naked eye, the best I can tell. The ... (cont.)

I would like to order an entire new 28 inch channel balance with the exact inside fittings as shown in the 2 pictures (if possible). The windows are 22 years old. All other channel balances on my windows are fine. Also, please give me a quote for replacement cost.Thank youLarry

Channel measures 28" (metal only) Stamp - 27 3 GX CMC 11

Could use a second opinion on the type of balance. These are for a Reliabilt(Atrium) windows. I know the weight since that is stamped on both balances, but my pictures don't specifically match up with any of the samples.

piece item is 2740 however I can't find what the series number is Thank you Looking forward to hear from from you soon Sam

This is a gapco window. Part number stamped on the balance is 1530 It is 15"

Hi, Sorry for the poor quality photos. Hope there is enough there for an expert to figure out. The metal length is 28 inches. Unfortunately, didn't measure the width. Let me know if this is not enough info. Regards.

i have four windows . they all need new counter balance aluminum window,single hung

Hello, I need to replace 4 block and tackle balances. They are 28 inches in length (metal channel only) and appear to have the following number identifier 27 3 JT CMC 2. Which of your products could be a possible replacement. Thank you.

I am looking for this snap in plastic glazing for a pennco aluminum window, 9/16" wide ,1/8" deep at top of channel, the piece that you see when installed is 5/16" wide by 1/8" .

Need to replace the right and left Window channel balance it is 27 inches long photos are from the right side balance of the window

Hello, I have to replace the part in the picture and I have no idea how to call it... On the part there are the following markings: 27 4 B.S.I 0L What should I order from SWISCO? Thank you, Claudio

Pictures of ends attached. FYI, I did weigh the windows and they're 20lbs.

Nylon pulley string broken, want to replace both balanced, measures 28" without end clips. What Swisscom model number do I order? Can I get Swisscom at retail vendor in local Denver area?

Metal channel length 28", width approx 9/16"

Hi. Looking for a replacement window balance. The metal channel is 28" long (excluding plastic ends). Thanks.

I am needing to order replacement parts for a window and want to make sure that I order the correct parts. I have attached pictures to assist in identifying the part.I believe that I need a part 2740 window balance. Do I need to order 2 of them for each side of the window?Any assistance with which p ... (cont.)