Viewing all customer Discussions for:

S380-28 28" Series 380 Channel Balance

Length is 28" for a CWS storm door for mfg house Part # on piece pictured is 27 2 RG

I would need 4 of these balances. I need to go back by the house today as there are smaller windows in the bathroom that need balances as well. I will get the sizes of them as well then order them all together.

Please let me know what is the correct part to order considering the above pictures of the plastic things attached at the end of the part. Some are marked 27 4 AP and some are marked "27 3 BP"

Hi, Metal length 28". Could you figure out what size window balance? Thanks

Would like to replace window balance with 2730 BSI (sideway) and NC stamped on old balance. The challenge seems to be finding them with winged plastic ends attached. The length of the metal part of the balance is 28". The plastic wings are 23 mm or 29/32" wide (slightly wider than 7/8" but not qu ... (cont.)

Please identify the correct part number for the ballast in these photos. I also need a part number for the take-out clip. The ballast is 28 inches long. Thank you.

Greetings, I need help in identifying the correct channel balance replacements for my window. The balances are for a non-tilt window. They are 28" long and the channel width is 1/2". The description on the balance reads 27 4 LP Caldwell. I have attached several pictures that I hope will help identif ... (cont.)

Two different windows, 26" & a 28". Shoes appear to be 1-1/32". I'm pretty sure I know what size but I just want clarification. Appreciate the help!

Length:28 inches (metal part) with winged top and shoe Width: 1/2 inch Markings: 27 3 DN CALDWELL Thank you

I need to replace 4 balances I have included the picture with some numbers

Hello! I need to replace the sash balances based on the dimensions below. Please see photos of the nylon footings for reference. Length: 28" Width: 1/2" Thank you!

Need to two of these Need to understand which one to order. Total Channel length excluding Plastic ends is 28"

Hello, I need new Channel Balances for my single-hung windows. I have non-tilt, 1/2" 28" long metal channels; winged bottom shoe is .97" deep x 15/16" & 1/2" wide; winged top guide is .72" deep x 1/2" wide; markings on Channel: 27_4; B.S.I; OM - see attached photoThank you, Brian ... (cont.)

Hello, I would appreciate any help in identifying my balance. It measured 28" in length, 1/2" width. It also has a marking of "27 4 EL Caldwell" Hopefully my pictures provide enough information. Thanks

Number stamped in ballast is 2790 13 If more info is needed please email me. Thanks. Phill

Need to know what part to order, dimension is 1/2 width, 28 length

Hi, I have a customer looking for (2) channel balances and (2) take-out clips for the above window. The metal portion of the balance measures 28" (29" overall) and is stamped as shown, otherwise no other marks.Philips DH-R30Series: B10 or 810 (hard to read the first digit)Code: RP-0403Regards,Ted ... (cont.)

I think one of the white plastic clips are broken. Insulated Windows look fine but Balances are all beginning to break. I hope my pics are going through. Please let my know if you need any other info. Thanks !!Vic

We have 3 broken balance channels for our 1982 57" x 34"aluminum windows and cant seem to find an exact match. The bottom piece of the balance channel seems to be rounded in all of the replacement channels we have seen and ours is pointed (best seen in last picture attached) - other than that they a ... (cont.)

Numbers on the bottom 27 3