Viewing all customer Discussions for:

S380-28 28" Series 380 Channel Balance

Hello, These are 2760, 9/16 wide. The sashes are approx 34 lbs. I need 6 total balancers. I want to make sure the ends are the same as shown. thanks!

I'm looking to replace 4 of my window balancers . The part number on the hardware says AJ BSI 2740. I'm unable to find this part number for replacement. Please let me know if this part number still exist or if it's been changed to something else. Pictures are attached for your review. Please take ... (cont.)

I'm pretty sure it's 380, 28-in, 1 inch width

My window balance has the following stamped on it: 26 4 GT CMC 2 I'm trying to determine what would be the correct replacment part. Thanks.

Windows are Jeld-Wen from mid 1990s. Length is 28". No identifying sticker or imprint on balance. From the window: The mfg code is JW-6. Series: Summit 7080ANSI/AAMA 101-93 There is a MST 4080/4060 and also a DH-R30/R35. The window is aluminum.

I LOOKING FOR A REPLACEMENT CHANNEL BALANCE

Hello. I have broken sash clips and need 4 of them. I also have one window balance that has a broken bottom clip which is riveted on so I will need the whole balance. The number 2740 is engraved but no other markings.

Found two different numbers. 27 4 08 and 27 4 nm. Two different windows . 28 inch metal channel length

I am looking for replacments for 4 differnent parts. All have the same type fittings. I have included photos of the side and underside views of the bottom and top nylon fittings Part #1. Stamped 33 3, channel measurment = 34" Part #2. Stamped 27 5, channel measurement = 28" Part #3. Stamped 27 3, ch ... (cont.)

The window balance mechanism says "27 3 B.S.I. 0B" The metal rod excluding the end pieces measures 28 inches in length.

Metal piece marked 27 4 BU CMC 4 fell off when opening and closing the window. The window pane eventually fell off entirely. Seems like a need a new metal piece. Can you help?

Please let me know replacement info.

Hello can you direct us to the replacement product. Thank you. 28in Code on bar 27 4 BSI PD

27 4 LP Caldwell; 28" long. Needing help identifying the appropriate replacement balances - will need 2 pair. This is a non-tilt window. Thank you!!!

I have two windows that need balancer replacement. The only description I see is 27 5 ET CMC 2. I'm including pictures. Please help me out.

The two sizes of window balancers I need are slightly over 28 inches and slightly over 34 inches. Window master is the window manufacturer. I need five of each size.

I need a couple of sets of these for some vinyl single hung windows.

I'm in of two 28" balances. Photos are of the original that have no #'s. I had replaced with 2740 years ago and just failed. The 2740 required a lot more effort to pull down so I the springs must've been too strong. Searching your product line I think I need 28" from your 380 Series, likely the 273 ... (cont.)

TRYING TO GET ASSEMBLIES FOR BOTH SIDES, NOT SURE WHICH ONE IT IS. NEED TO KNOW WHICH ONE TO ORDER

28" 2740 & 2730 window balance winged guides