Viewing all customer Discussions for:

S390-26 26" Series 390 Channel Balance

Can you identify this balance?

Hi I have a 9/16" channel balancer that needs a replacement part. It's 26" and I was wondering if the 16 is the amount of weight it can hold up. I don't have the sash size, the customer only brought the part needed.

Only markings because it's old and rustic is 25 B

The cord is breaking, I need replacement.

I have aluminum non-tilt hung windows in my condo. The balance top and the top sash guide are most unusual. I don't see them on your website. Can you find them?

Metal measures 26" Window weighs 45.5 lbs See photos. These are NOT the original balancers, and they have failed within a year. Mat be the wrong ones? The Windows are Quaker aluminum.

I need to replace the balance the number is J 2540 included some pictures .

My window balance rod is stamped 2520 BSI as in the attached photo. I see that you have that part but in a number of different series. How do I know what series to order? Thanks.Nelson

I have a 1/2" wide window balance I need to replace. It measures 26 1/16" from end to end on the metal frame only not including to plastic attachment pieces. Thank you for your help!

Can you tell me which channel balance I need to replace this one 2590BSI RV 34? I need take out clips as well.

26 inch long by 1/2 inch. The window go up and down.Thanks.

Hello,I need 2 balance replacements assemble including all required parts ready to replace the exiting Balance. Dimension: width 1/2 in, length of the metal part 28". See also 100/101 pictures attached.Please note; I need a complete balance assembly that is include all top/bottom small plastic parts ... (cont.)

all balances measures 1 inch longer then part #'s. Thanks, John

I ordered the channel balances only to discover that it was the plastic piece on the window that needed to be replaced. Argh! The channel balance numbers on the windows are 2520 and 2830's. If you could ID the part in the picture and send me the part number for ordering, I would appreciate ... (cont.)

Please advise on what is the appropriate part. It is stamped 2550 32 on the channel itself. The metal part is measured at 26 inches. I did not see the exact top of foot matching to what you have listed.

Hello, I had started a thread with you about a week ago and have not been making much progress. I just spoke to someone on the phone and he asked me to resend everything so here it is again: We are looking for replacement Channel Balances. They are 26" long, 1/2" wide. I've attached photos ... (cont.)

I have a window were each side load B & T is broken and would like to buy 3 sets. I think the window is a plygem. What is the difference between the S350-26, S351-26 and the S390-22. When I took the existing window apart I don't rember seeing a section that was 26" long. Do these come in shorte ... (cont.)

please help identify and order the correct part for my window

Can someone help me identify two channel balancers I need to replace? Attached is a two page pdf showing the markings on each as well as dims of the top/bottom parts. Thanks, Matt

Is there any way to identify a balance when the bottom shoe is damaged? This is on both sides of the window. 26