Viewing all customer Discussions for:

S795-16 16" Series 795 Channel Balance

Need 2 for both sides of window

Hello I am in need of two block and tackle track assembly parts. Basically everything that you see in these photos. It looks like the number on the side of the track is 16 C which I'm assuming is 16 inches of metal track. hope you can help me with this. Thanks. Kory

Good morning, Looking for a replacement block and tackle setup for Pella, circa 2010 manufacture. I am able to reuse the existing shoe guides if needed. The original block and tackle fit very snugly into the side channel of the window(FYI). Look forward to your response. Thank you. Eric ... (cont.)

The Tlock shoe on both side of my Pelham window are broken The balances are fine I am having trouble to remove the tlock shoes from the channel. I might have to cut a slot on the top of the window track to remove the Tlock.. But how will I be able to hook it to the balance?

I need a replacement part (qty 1) for Pella channel balance. It is 16" long

Please find pix of 16"x 1/2" channel and parts from 36x37 Pella replacement double hung w tilt out. Some of the parts are broken and not entirely sure which new ones I need. Many thanks. DB

Two Balances are need for a Pella ThermaStar Double Hung Tilt Window. Window Info as follows: 2432 Window Top Sash 13 PELLA JUN22011 IGCC?/IGMA? W0202346975 NFRC PEL-N-108 Bottom Sash 14 PELLA JUN22011 IGCC?/IGMA? W0202346975 NFRC PEL-N-108 Balance Marking - 16B BSI EP Assistance is appreciated t ... (cont.)

16 inch, stamped numbers: 16C BSI RG(small stamp, difficult read) Pivot lock shoe was difficult to remove, slid up the channel but it did not have wider gap? I don't see a match here.Pivot bar is 2 1/2 inchesI need the window channels, the pivot lock shoes and the pivot bars. I also need suggestio ... (cont.)

Having an issue confirming the correct replacement piece to replace a channel that broke. It's a tilting window with 16" long and 1/2" wide channel with a 16C designation. The existing channel is held in place at the top via terminal clip that look different than the Series 795 connection at the t ... (cont.)

Pella window 2 Balance and shoe needed had a green clip in the shoes

Can you help ID this weatherstripping for the same window? The metal portion is 16" long and is roughly 1/2 by 1/2 an inch, slightly over. The stamp says 16C BSI. Open or closed cam, I am not sure but here is a pic and i think i should replace the entire unit as on of the cams has a broken pie ... (cont.)

Hello Was needing some assistance ensuring I purchase the correct balances. Please see the pics. One is 16c bsi eb and the other is 25b bsi ec. Thank you,

Good morning, I have a window, 18.25 tall and 33 wide with a 16" long metal balance that has a 3/4 inch long twist hinge connector, making the balance be 16.75 long. These are the pics I could take without removing one of them. And also the weather stripping is ripped and needs replacing. Can y ... (cont.)

I need a count of 4 of balances that are shown in the pictures.

Balance is 16 inches long by 9/16 by 9/16 string and hook come out at end of balance not able to take picture of it installed window is in a camp out of state in MaineI will be needing 2 of them

Looking for assistance to replace a window balance. Attached is a picture of the stamp on the balance as well the top of the balance. I am thinking I need to remove the top/ rubber casing to remove/ install the new balance? Thanks Bill

I need the little gray part that attaches to balance.

I cannot find a logo to help me identify window manufacturer. The channel itself has this stamped on it: 16C BSI TK

the small connector (3 parts) is damaged on the left side. It also gauged the plastic channel. I included part number off the channel balance in one photo. I need the 3 damaged connector parts. How can I recondition the plastic channel so it is smooth and window will glide again? ... (cont.)

We have a bathroom window that is broken. The bottom part of the window folds out so that it can be cleaned. There is a spring loaded slide on both sides. The slide is metal and is silver in color. It has the following writing on both sides and is 16 inches long (16DC BSI). This part at the bot ... (cont.)