Viewing all customer Discussions for:

82-238 Double Hook Mortise Lock

I am looking for the I believe it's called a doorkeeper? When the last owner put the door in they didn't put that keeper in place and they basically just kept the door locked with a broom handle. Thank you for any info NAMI: Series: Newcastle XT/ Insulate 960

Need white [preferably) sliding door latch / lock set for replacement . Mounting holes are about 3 and 7/8 in. apart. Latch hole is about 2 and 7/8 in. from mountin holes. Previous lock had 2 locking prongs and had keyed lock on the outside. Door frame is 1.5 inches thick, do not know the manufactur ... (cont.)

I AM LOOKING FOR THIS DOOR LOCK ASSEMBLY FULL PACKAGE ITS A BACK YARD GLASS SLIDING DOOR LOCK. I AM UPLOADING COUPLE MORE PCITURES.THANK YOU ALI

its says made in New Zealand PAT Pending

We have a lock which appears need of replacing. For the sliding glass patio door. Multi point measures 6.5 inches from screw to screw. The locks measure 2 7/8. The lock mounts flush in the door. It is a vinyl door. The only identification is New Zealand.

5"hole to hole 2"thick door with center lock

I need to replace a missing sliding door latch keeper that was removed to install a dog door. Not sure of the make of the door. The label on it is deteriorated but looks like it reads SGD-R2(0?.) The door is 71"w x 78"h. The spacing of the mounting holes for the missing part as shown in the photo ar ... (cont.)

Hi, It is a Misguard sliding patio door (Supposed to be)The keeper is missing. The frame shows it had 4 holes for screws.The LATCH LEVER is broken. The one on your site looks different and has different dimensions. I found the model of the door.Can you please help me?Thanks

Do you have this part

This lock lacks the part that should be in the door frame... the part the lock should "grab."

I'm looking for a replacement lock for my sliding glass door. Can you please help me with this? Thank you!

I need to replace the lock part of this, if not possible the entire handle please.

I need replacement part for this sliding door mechanism.

My double prong sliding door latch will not lock. I have to push the metal tab inward which is located in the middle between the two prongs to allow the latch to move to the locking position with the door open. Once I unlock the latch, still with the door open, it sticks again and will not allow the ... (cont.)

My door is stuck in the unlock position. I can spring the lock by inserting a knife in the mechanism, so I know it has two lock hooks. It has a keyed entry but I don't seem to have keys. Which parts should I order? I don't care about external keyed entry but I do want to be able to lock and unlock t ... (cont.)

Would you have replacement parts for pictures 211001 and 15657. The latch pin broke off and handle. The handle says it was made in New Zealand if that helps at all.

I have a Legance2 sliding patio door. The posts attaching to the locking mechanism broke, so I need to replace the whole unit. Note that the base of the handle is slightly curved (not straight). I also photographed the ID label found inside the right end of the sliding door. The base of the handle i ... (cont.)

I am looking for an inside replacement handle (or an entire inside and outside replacement kit) and a replacement screen door. Please let me know what other information I can provide. Thanks - BC

Mortise lock does not match up with handle set and attach to keeper (Stryker) one door frame. Please contact me with why it does not lock properly.Thomas

I'm in need of a sliding door handle and mortise. The patio door handles are 5 inches apart with a center turn to lock. The mortise is missing, but the hole measures approximately 7 inches long by 9/16 wide.