Viewing all customer Discussions for:

39-332 E-Z Straight Arm Operator, Andersen

the opener is from an Anderson Window. From the rivot on the end of the arm to the center of where the arm meets the mounting bracket is 14". The base is 5 3/8" wide. It has the following numbers on the top of the arm: 1 361 485 R & 1 361 482 HOP It has the following numbers on the underside of t ... (cont.)

Need a new opener unit. Internal mechanical parts seem all wallrd out. 16 inch arm Anderson opener. I'll also need any required hardware to replace. Thanks!

Under the cover of the operator are two codes - B61529 &. B61530 At the end of swing arm it attaches to a track with a pin, and then that track has rollers in it. There are numbers on the hinge, part of the window plate and these are. 0618707. & 1361348.

i believe these are the original windows and the house was built in the early 80s near sacramento california. the interiors are wood and the exterior seems to be clad with vinyl. i will be so appreciative if you can help me find the handle and other parts! thanks.

Stripped. Does not crank. Need parts, please.

Hello Tech Support,Looking for this Anderson casement window operator. The arm length is ~ 13 1/4 inches from the crank pivot point to the pivot point on the slide shuttle on the window frame.Also looking for replacement patio door roller assembly shown too.Thanks Paul

Can find the part by these numbers I found on the mechanism

My order number was 1759286,these were parts of Andersen - straight arm operator and Tandem stash Lock. These parts did not fit and I returned it back. I have uploaded the pictures of the parts that is currently on my Window and looking for the correct replacement parts. Please let me know the corr ... (cont.)

Hi- I need new handles and encasements for my Anderson windows and I am not sure which product will fit. I appreciate the help. Thank you. Lou

Would like to purchase two cracks

Crank is not moving windows Not engaged inside

Looking for a replacement for window crank operator, Anderson window, installed 1999. On part has nubmer F 9400 8a

Greetings. Our Anderson Window, Model Number:.PSC-WHWH-L-HP-22IN.needs a replacement crank assembly, as the old one is stripped. It has a 14 inch arm. Can you match the above assembly for us? Thanks! Jim

C-9400-1. 1521101.

13 inch arm, number stamped on arm top row = 1 361 485r. Second row= 1 361 482 hcr I need a left and a right. I ground off the rivets and opened the mechanism. Found teeth ground off bevel gear that handle attachesboth left and right window. The vise grips in the picture are holding it together ... (cont.)

Hello, Been having problems with window cranks on several windows. They have C-9400-1B with 1 361 405L arm. It appears 39-332 is the replacement for these. Can you please confirm before I order multiple for my windows. Also, can you comment on reliability since several(4) of my windows have the sam ... (cont.)

Need 2 replacements cranks but not sure what type to order- please advise! Thank you!

Hello looking for Anderson casement crank replacements . Need one of each of the following :1) 1 361 485 R 1 361 482 HCR 2) 1 361 485L 1 361 483 HCRPlease let me know what I should be ordering. The arm from center of pin( under glass) and center of screw (at crank base) is 14" see attached photos. ... (cont.)

I have a couple anderson windows that need new roto operators that I am unable to locate anywhere. The arms are 14" long. The windows are actually KML archtop casements that were sold by Andersen.

Like to buy some window crank replacementsAnderson part number is c-9400-1