Viewing all customer Discussions for:

39-348 Sill Mounted Awning Operator

Hello i was wondering if u carry this piece that screws on to the window crank handle helps open window by helping turn gears inside to open window, not sure the name but its missing from my window. Please see picture i attached the hole diameter thread is about 11/16". The handle brand is a weather ... (cont.)

I need to replace the whole mechanism but I do not have any window information to give you

Hi. I need to replace this crank handle because the inner rotating part seems stripped as it does not pull the window closed anymore. Can you tell me the replacement part id or number I should order? Regards.

Our Transom window opens when cranked but when trying to close the window it stops closing even when cranking closed. It appears that the threaded ring piece on the crank arm holder is not seated properly in the hole. We have a second transom window and the threaded ring piece is seated within the ... (cont.)

Mounting plate is 5" x 2", arm width at widest disconnected position 24.5", mounted with four screws two 1" and two 3/4", mount color bronze. Numbers/markings found on under side of mount: - PAT Canada 1986 - US PAT 4505601 - 45206 - MADE IN USA - TRUTH

My house was built 23 years ago and has six awning windows across the front dormer. Two of the gear mechanisms have broken and I need replacements. They are Crestline windows and the part is no longer available. I am attaching pictures. Please help me. The arms are 8 inches long. When the window if ... (cont.)

Have 20 year old Marvin awning window in the garage that the crank shaft snapped off. The arm is 9 1/2" from center of arm pivot to the center of the gear. The top set of screw holes are 3" on center. This is a Trust operator with the number 45251 stamped on the bottom. I have found a couple of o ... (cont.)

This is an old awning window The mechanism is 5 inches wide The length of the arms is11 inches

I am looking for the casement hardware for these windows (I believe it is K and K hardware). Do you carry this piece? I couldn't read any numbers due to rust. Thanks

Im looking for a standard Thomson awning window operator replacement. There is 3 screws to hold the operator done, 5-3/4" between the 2 outside holes. There are 2 arms about 18". The arms connect to a sliding track on the window

I have an awning operator. There is a stamp Truth. It cranks in the middle it has dual arms that connect directly to the shoes. It is not 11 series model. I cannot locate this part. Home was built in 1979

We would like the complete part as shown above Part number on the long arms are 40011 and 40012 the mechanism is 45301 Handle is 45054 It says the manufacturer is truth

I have the original order contract from when we built the house. The window description is... WAW3-402031 000 E317E. Awning 12' width x 2' height. I need the open and closing gears replacement. My name is Gloria .

The crank does not close window. It will open but it skips, when taking the piece out that I'm holding in photos it appears damaged. Can you replace that piece I'm holding or do you need replace entire operator? Which swisco part would replace this ? The operator arms are approximately 11.5 inches ... (cont.)

Hello,I have four dual arm awning operators manufactured by Truth in my home. I believe the correct part number is 11.16.32.001 but I but I am not sure. A photo is attached. The hole to hole distance is 24".I would like to purchase the following. 1st choice: covers and nested folding cranks in white ... (cont.)

I have THRUTH awning windows that came with my house. One of the boot ends that holds the bar to the window broke. Any idea where I can get replacements?

I need the part to replace the cranking arm window that cranks up and down. The 2 arms are about 11 inches long, handle is a one piece and is not removable . There is no name on the window.

What do you think?

need new arms for Norco crank windows. Part 40759. Need the bar that attaches to the window and the piece with the 2 arms, and the clips. Preferably 2 sets

Hello - I am looking for a replacement operator for a ~2004 Jeld Wen awning window with a Truth Entrygard 40761 operator. What is an adequate replacement? Thanks. Tom.