Viewing all customer Discussions for:

39-350 Look/Rusco Awning Operator

I need to replace this part wich open the window by crank the lever If you have the part let me know Thank you

Good Afternoon, I am searching for the closest awning operator based on my photos. The 39-061 has worked in the past, but the windows I am working on now are different than my order from 2023.

I would like how buy tosse part

I am hoping that based on the 5 pictures with the dimensions you can identify this crank. The awning windows are on a house built in 1925 I suspect they are not original but may be quite old. I will need 6 of them. The thread in the hole is 14-20.

I am looking for a Right hand window crank. The windows were bought in Flria around 1975 - 1977.

Hand crank for 60+ year old house. Thank you.

I have a few of these that don't work well in my house and my windows won't close properly because of it. The main issue is that they will open fine but when I go to wind it shut, the handle will just unscrew itself from the crank. Replaced one with what I could find at Home Depot but doesn't work w ... (cont.)

Looking to replace 11 of the same style cranks and associated screws and hardware. 8 are mounted on the right hand and 3 to the left. Also looking for a recommended lubricant and maintenance manual.

Good afternoon, I looking to replace my awning operator. When we had it out, I measured 5 1/2 inches in length between the top and bottom holes and 2 3/8 between the holes on the little arm and 1 1/4 between the bottom holes. Such little differences in the measurements make me uneasy! ... (cont.)

Can you ID this part? Top hole is offset to the left. Top to bottom hole spacing is about 5.25". Bottom hole offset is about 1.25" Arm length is about 2.00"

Cast aluminum hand crank for 3 panel louvered window.

Need 2 of these.

I'm trying to identify which operator I need to buy. The hole for the operator arm is threaded, but I don't know what type of threading it uses. I also don't have the name for the window manufacturer as they are all illegible now. The house was built in 1966, and the identifying markings are long si ... (cont.)

Need three right operators and one left operator for 45 year old windows. Want to buy one right initially to ensure fit and function. Arm length is 2-3/8" - not sure about thread dimension. C-C vertical length is 5-1/4". If colors are available, white is preferred. Only information on existing close ... (cont.)

I wanted to know if you knew a replacement part for this hand crank. There are no names or numbers on the windows or cranks that I saw. Thank you for your help.

SD only marking It's a right hand operator

Window doesn't close completely please attached picturesThe part appears to be 2" x 5 7/8". Approximately if you don't feel the operator is the issue please make recommendations. ThanksGavin.

I've been trying to find a window crank so I can fully close my windows. Unfortunately, I don't see any part numbers, and the part I ordered from Amazon, is not the correct fit. Please help? Thanks!

The units have right and left side cranks the spread from top screw to bottom screws is 4-3/4" center to center the windows were from the late 1950's. Are any of your products a match?Thank you,Frank

Dear Swisco, I need to replace my Window Operator on my Florida Awning Windows in my Florida Room. The only Operator that is fairly close to mine is the 39-350My operator's arm though is off set and has a threaded piece at the end of the arm that slide into the hole in the shoulder and a nut to ... (cont.)