Viewing all customer Discussions for:

39-350 Look/Rusco Awning Operator

I'm trying to find the replacement handle for one of my sunroom windows, but the part doesn't have any part numbers or identifications.

Because I repair my own awning windows, a friend asked for help on theirs.I have not found any identifying information on the window or operator. She has a whole houseful of these. The pattern on the operator housing is unlike any that I find online. If you need any further details, please let me ... (cont.)

Hi all, Hoping to confirm a part number for 6 left hand replacements. Hole spacing is 1 1/8 x 5.25 with a 2 3/8 arm. Some of the arm attachments seem to be via c-clip and others by threaded grommet. Also looking for an extended or straight crank handle. One was installed in a corner beside a door ... (cont.)

Hey there, my name is Chris. I want to thank you in advance for your help.I am looking to replace several Lemco Series 30 window operators. I see that the Look/Rusco 39-350 is an exact match in all areas EXCEPT the swing arm on the gear mechanism that goes inside the housing and is turned by the cra ... (cont.)

The arm measurement is 2 5/16 and the screw hole is 3/16 threaded The distance from top to bottom hole on center is 5 1/4 Distance between bottom 2 holes on center is 1 1/8

Hello My name is Ken I need both LH & RH vertical rollera. Isee no name or numbers on window or rollers, but here are the measurements. The roller has 1 hole in the top-- two holes in the bottom.Overall length-5-3/4in . width-2in.c-c top hole -bottom hole-5-1/4 in, ( not aligned) c-c bottom hol ... (cont.)

LEMCO SERIES 30Will you need photos of the inside of the current broken crank to determine what model I need to buy

Looking to get name of arm as well to see if they make arm extenders for windows hard to reach.... I do believe window is from the 60's

Looking for replacement aperator

Trying to locate a replacement for the pictured window crank. Approximately 50 + years old

Help

Hello, I need 1 left and 2 right of the awning window operators that are in the attached photos. Thanks in advace! Arnie

Unable to find replacements at any local stores. Can you help me out? Thank you. Gabe

NUMBERS STAMPED INSIDE OF CRANK HOUSING. PAT. NO. 198202 US 2 R.H. RD1963 CAN. STAMPING ON INSIDE OF HANDLE 11500-11

Will one of your products replace this? Is this a right or left crank? Thank you

The hole spacing for the bracket is the 5-1/4" top to bottom. The operator link arm is 2-3/8". The issue is the handle comes out of the operator when closing counter clockwise at about 30% remaining before secure. Operator can open windows fully and bring them back in to some degree. Sunroom was ins ... (cont.)

I need this ASAP. I have sold my house and this repair is on my inspection list

Hello, I'm looking for window cranks that match. I have 3 similar windows with holes that fit this type of crank. Can you help?

Need a new operator for this really old awning window. Top to bottom mounting hole distance 5 1/4" bottom holes distance 1 1/2" Operating lever 2 1/2 " center pivot holes. 2 pictures attached

Markings inside read 3RH 18-0821