Viewing all customer Discussions for:

26-378 3" Pivot Bar

We Need to get a few of these replacements it is rated at 440

My measurements are 3/8" regress and 1 1/4 wide. I believe I know what parts I need but I wanted a professional suggestion. Thanks, Troy

I am trying to replace the balance on a Simonton single hung window. Both of the balances need replaced. The entire balance needs replaced but the sliders appear to be fine. There is a metal bar on the bottom of the window that needs replaced on one side. This metal bar is what connects the wind ... (cont.)

Hi, i have a simonton double hung window, part number photo attached. I need to replace the following parts but not sure what parts in your catalog: 1. pivot bar-left and and right 2.2 tilt latch left and right 3. pivot shoe left and right. Please advise correct parts number Peter ... (cont.)

We have several windows that will not stay open and will fall HARD if opened. We can't get any answers as how to repair

Can you please identify this pivot bar and window manufacturer? I have tried your model 26-378, but will require some work to make it do. The dimensions are right, both overall and hole spacing, however my pivot bar holes are tapped to accept 6-32 screws. In addition, as you can see in the photos ... (cont.)

I need to know what parts to order. I need the lower window seal, and also some of the t post and slides as the do not move easily. Thank you for any help

This balance and pivot pin are from what I believe is a Capital double hung window. The upper sash weighs approximately 17.2 pounds the lower sash 18 pounds. This double coil balance is installed to carry the upper sash, the lower sash has a single coil balance. Both pivot pins have a T head The h ... (cont.)

the balance spring has a 7 # 35 on it? these parts came off of an MI window model # 350. I need both the right and left spring and shoes along with new sash pins

Sorry I have only part of the bar there are 2 screws , Thank you Steve

I am looking to purchase 150 to 200 window balance and glides for many windows in my townhome community. Please see attached photo of what we are looking to replace. I believe we have found the correct parts on your website but it seems that we will need to order each piece separately. The ... (cont.)

we have a broken pivot bar that is too far in and can't get out. suggestions?

Hello, I need to order some window pins for TRACO windows. The pins are about 3 inches long. I did not see any on your website, so I wanted to see if you may have them in stock to order.Thanks!

How can I find some simonton balance assemblies for my windows.... some of the coils springs are broken and the metal parts on the shoe assemblies are broken.Part# is 801030 on the balance plastic casing. I have attached 2 photos. Can you help?? Carl J

I need to replace a couple of the broken pivot for my windows and I found this closest match (26-378) but I need it to be 4 hole instead of 2. Would you have it? Thanks.

My question is, when a portion of the pivot bar is broken in the window track how do I extract it? it wont slide out! or do I just push in what is there with the new Bar?

There are broken parts in two places on my window. The window won't stay up now when we open it. Please see the uploaded photo.

4" L x 1.250" W x .500" Thick. Please find photos of Assy and post bar. Do you have similar components? My pivot locks are completely eroded.

I am trying to replace a broken pivot bar for a window in my house. I do not know the manufacturer of the window, and there do not appear to be any names, numbers, or markings anywhere on the window as a guide. I'm attaching a picture of the pivot bar from another window in the house. Any assista ... (cont.)

Here is a pivot bar for a tilt window. It is bent and the measurements are off slightly. I have no information on the manufacture of this window. Can you help me find replacement pivot bars.